this procedure through the debugging process, with I2C bus function procedures.

Keil C51 上51系列单片机优化的CRC－8 算法。可以自己改其他算式的，包含字节查表，半字节查表，bit计算。很难得的哦。-Keil C51 on the 51 computers optimized CRC-8 algorithm. Other formula can do it ourselves, and look-up table contains the byte, half-byte look-up table, bit computing. Hard to come by Oh.

初学单片机的一个实例运用，以at89c2051为例，用c语言编写的时钟程序。程序采用了两级中断，具有时钟及秒表功能。-beginners MCU use an example to at89c2051 example, the language used c clock procedures. Adoption of the two suspended, with the clock and stopwatch functions.

Ti 公司低功耗RF芯片选型资料.其中有13.56-27MHz,300-1000MHz ,2.4GHz等等芯片选型参考-Ti low-power RF chip companies Selection information. Among them, 13.56-27MHz ,300-1000MHz, 2.4GHz chip, etc. Selection of reference

read and write eeprom,at24c512.debug finished pass.

i2c总线eeprom读写程序 可以读些从21c01--24c512的i2c总线eeprom芯片-i2c bus EEPROM read and write procedures can read more from 21c01-- the i2c bus 24c512 chip EEPROM

：章介绍了数据采集系统中STC12系列单片机与PC机之间的串行通信。设计了sTc12c2052AD 与 MAX232的硬件电路，使用汇编语言编程，设置了串行1：7的工作方式，相应的波特率计算方法及特点，发送并接 收数据。单片机从EEPROM 中读取数据，通过R．S-232将其传入PC，并将数据存储在24C02中。-: Chapter introduces data acquisition system STC12 Series MCU and PC serial communication between machines. Designed sTc12c2052AD with MAX232 hardware circuit, the use of assembly language programming, set up the way the work of serial 1:7, the corresponding baud rate calculation method and the characteristics of sending and receiving data. Single-chip EEPROM read data from, by R. S-232 to incoming PC, and data storage in the 24C02.

此程序为单片机89S52液晶显示模块显示程序.具体解释在程序中有.-procedure for SCM 89S52 LCD display module procedures. Explain the procedures are.

AVR单片机用C语言编写的包括时钟，LED，KEYPROCESS如何设置，是关于一个仪表的全套程序-AVR Singlechip with C language, including the clock, LED, KEYPROCESS how to set up, on a full range of process instrumentation

MSP430单片机的开发板原理图，用于初期对430单片机的学习，也可自己制作开发板-MSP430 MCU development board schematic diagram for the early stage of 430 single-chip learning, can also produce their own development board

把单片机串口通讯改造为SPI通讯接口源程序，使用C51语言编写，可以用于MCS8051单片机-put microcontroller serial communications to transform SPI interface source, the use of C51 language, which can be used Mcs8051 MCU