本方法的基本思想就是利用单片机具有的PWM端口，在不改变PWM方波周期的前提下，通过软件的方法调整单片机的PWM控制寄存器来调整PWM的占空比，从而控制充电电流...

JUPITER演示程序，uart串口通信-JUPITER demo, uart serial communication

这是一个关于DS18B20的温度采集系统的设计，能够通过修改本程序从应用到你的系统中去-This is a study on the temperature acquisition system DS18B20 design, able to modify this procedure from the application to your system to

8051 F330 6位数码管显示 倒记时-8051f330 6 bit digital tube display

：章介绍了数据采集系统中STC12系列单片机与PC机之间的串行通信。设计了sTc12c2052AD 与 MAX232的硬件电路，使用汇编语言编程，设置了串行1：7的工作方式，相应的波特率计算方法及特点，发送并接 收数据。单片机从EEPROM 中读取数据，通过R．S-232将其传入PC，并将数据存储在24C02中。-: Chapter introduces data acquisition system STC12 Series MCU and PC serial communication between machines. Designed sTc12c2052AD with MAX232 hardware circuit, the use of assembly language programming, set up the way the work of serial 1:7, the corresponding baud rate calculation method and the characteristics of sending and receiving data. Single-chip EEPROM read data from, by R. S-232 to incoming PC, and data storage in the 24C02.

29个单片机实验（转载）-29 SCM experiment (reproduced)

集成CAN总线的单片机连接图，包括ad转换，电源处理，通过232与主机的通讯--An SCM connection graph of integrated CAN bus, including ad conversion , power treatment and the communication with main machine by 232.

一组实用的C51源代码,不是我作的,在网站上载下来的,也许对大家有用,感谢作者-a group of practical C51 source code, I am not for the website, in the set down, perhaps useful for all, to thank the author

16单片机AD转换一般有连续转换和中断转换两种，本程序采用中断的方法实现AD 转换-Single-chip AD converter 16 for conversion and there is a general disruption of the conversion of two, the procedure of the method used to achieve interruption of AD conversion

精电的12864驱动原码，asm和c.-Varitronix drive the original 12,864 yards, and c. asm

1.将P1.0～P1.3接开关，将P1.4～P1.7接发光二极管。依据P1.0～P1.3开关状态控制P1.4~P1.7发光二极管点亮。 2.将P1.0～P1.7全部接发光二极管，开始P1.0、P1.5点亮，左循环50次后P1.1、P1.4点亮；右循环30次，循环往复。-1. P1.0- P1.3 will then switch to P1.4- P1.7 access LEDs. P1.0- P1.3 based on state control switch P1.4- P1.7 LED lights. 2. P1.0- P1.7 will take all LEDs started Schematic, P1.5 lit, the left circle after 50 P1.1 and P1.4 lit; Turn right circle 30 times repeated.