本matlab函数实现基带信号的成形和眼图的观测，其中眼图的观测函数可以判断码间串扰的强度。...

用LAPLACE方法求解多维沃尔泰拉方程，此处为一个变元的方程，由于该方程同时含有微分和积分，一般求解有一定的困难。此处为MATLAB程序，注意不同的初始条件(used method for multiple preoperational Ertaila equation here as a variable element of the equation, As the same time contain differential equations and integral, the general solution is definitely difficult. MATLAB here for the procedure to different initial conditions)

双边带DSB、单边带SSB信号调制解调正交解调算法(DSB DSB, single sideband SSB signal modulation and demodulation)

SPLINECHUIWAV generates the Chui semi-orthogonal cubic spline wavelet

The simulink model of Back propagation Algorithm using an Adaptative Filter.

盲源分离算法，基于最大信噪比实现，包括源程序和算法说明(Blind source separation algorithm, based on the maximum signal to noise ratio to achieve, including source code and algorithm description)

连续相位调制信号(CPM)产生，计算十字叉丝的在不同距离的衍射图像,包含收发两个客户端的链路级通信程序,考虑雨衰 阴影 和多径影响，中介真值程度度量，基于中介真值程度度量的图像分割关于小波的matlab复合分析。

dab仿真程序，包括接收发送和AWGN的性能 (dab simulation procedures, including sending and receiving AWGN performance)

main executing reference usage: usage_timeDifference.m Sample output: The time interval between earierTime [09-Sep-1900 09:09:18] and laterTime [31-Oct-2010 23:33:08] is 110 years, 79 days, 14 hours, 23 mins, 50.17 secs. The objective is to compute the time interval taking into account the leap days that are subsumed within the time interval. Note: The logic subsumes the time interval by yearEnd, monthEnd, dayEnd - timeEarlier (within that year) + time interval (excluding that 2 years) + timeLater - yearEnd, monthEnd, dayEnd (within that year) It differentiates the earlier time and later time, ie. timeDifference (earlierTime, laterTime) gives the same result as timeDifference (laterTime, earlierTime). leapDayHasPassed.m illustrates a possible approach to determine if a certain day of concern is already over at a given time. Caveat: does not include leap secs

用matlab来实现的衍射模拟实验，便于教学中立体的观看实验结果，这是很好的(using Matlab to achieve the diffraction experiments to facilitate the teaching of stereo viewing the experimental results, This is a good)

基于SVPWM的三电平逆变的matlab仿真，DC-DC部分采用定功率单环控制，多抽样率信号处理，pwm整流器的建模仿真，实现串口的数据采集，进行波形数据分析。( Based on SVPWM three-level inverter matlab simulation, DC-DC power single-part set-loop control, Multirate signal processing, Modeling and simulation pwm rectifier Achieve serial data acquisition, Waveform data analysis.)