缺水传感器V1.0，绝对原创，传感器好

利用单片机设计一个显示温度的系统，主要采用的是静态显示的方式-The use of microcontroller design a show that the temperature of the system, mainly in a static display mode

将单片机的IOA0~IOA7分别接按键S1~S8连接到高电平上。此时，如果某个按键被按下，对应的I/O端口就会输入高电平进单片机，即按键S3按下，IOA2会输入高电平进单片机-Will Singlechip IOA0 ~ IOA7 access keys, respectively, S1 ~ S8 is connected to high on. At this point, if a button is pressed, the corresponding I/O port will enter into the high single-chip, that is, S3 button press, IOA2 will enter into single-chip high

为了进一步理解上述方法如何在编程中得以实现，在此提供了1个用C51单片机编程语言编制的8个按键的键处理程序，以供参考。该程序在KEIL C51 V6.02/uVsion2 demo编译环境下编译通过-In order to further understand how the above method to realize programming, provided in the C51 single-chip microcomputer with a programming language produced by the eight key key procedure for reference. The program in the KEIL C51 V6.02/uVsion2 demo compiler compiler environment through

出租车计费系统 里面有相应的键盘扫描程序，以及相应的 显示模块-Taxi billing system there are corresponding keyboard scanning procedures, and corresponding display module

51读写U盘全套技术资料,原理图,KEIL C51原代码-U disk 51 to read and write a full set of technical information, schematics, KEIL C51 original code

用AT89C2051实现程序A/D转换程序，用PWM模拟输出。-Procedures using AT89C2051 realize A/D conversion process, using PWM analog outputs.

C8051F040 T4捕捉测脉宽 T3频率方波输出T4捕捉测试程序-C8051F040 T4 capture measured pulse frequency square-wave output T3 T4 capture test procedures

ST736单片机，驱动液晶芯片HT1623-ST736 MCU, LCD driver chip HT1623

591单片机CAN模块A51DEMO程序-591 SCM CAN module A51DEMO procedures

160104S6B0719(iccavr) form ouravr.com