本程序用于用单片机控制步进电机的转动。用单片机的某一个引脚实现控制，如果引脚电平为高则实现正转，反之为反转。所用单片机为日立系列h83664十六位单片机。本代码...

应用于ARM单片机的LCD1602的驱动代码-Applies to ARM MCU LCD1602 driver code

MSP430的PWM的输出实现程序，非常 实用！-MSP430 output of the PWM to achieve program is very useful!

这是我画的步进电机通用的驱动板，当然只是应用到初学者，版胡德不是很好，希望大家多多指教。-This is my painting of the stepper motor drive GM board, of course, only applied to the beginner, not a very good version of Ehud, I hope everyone exhibitions.

x5045有四种功能：分别是上电复位、看门狗定时器、电源电压监控和块锁保护串行eeprom的功能， 该程序通过改变控制寄存器的参数可以实现看门狗定时器监视电压和设置保护rom区，每次复位后 地址计数器都是该区的首地址（个人观点），即断点地址。 问题：其实对该芯片的应用还是很模糊-x5045 four functions : the reduction of electricity, watchdog timer, Supply voltage control and protection block serial eeprom lock function, The procedure by changing the parameters of control register can be achieved watchdog timer and set up surveillance voltage protection rom, After each reset address counter area is the first address (personal view), breakpoint address. Question : In fact, the application of this chip is still very fuzzy! !

12232 Lcd c51例子-12232 example Lcd

C语言编写的关于51单片机与矩阵式键盘的接口程序-C language on the 51 SCM and matrix keyboard interface program

proteus中文资料,学习proteus的好东西来的,要的就下吧-Proteus Chinese information, learning Proteus good things come to the right on the next

本程序为RF收发程序，采用外部中断判断脉冲长度，通过遥控接收程序。-This procedure for the RF transceiver procedures, using external interrupt pulse to determine the length of the procedure by remote control receiver.

一个用PIC16F84A做的音乐门铃源程序-A PIC16F84A to do with music doorbell source

该程序能捕捉到单片机发出的正确信号，并显示出来