步进电机四轮驱动

UC/GUIARM汉字内码处理建立汉字模值表-UC/GUIARM Chinese characters within the code module to deal with the establishment of the value of table

51单片机在lcd上实现zlg gui,希望好的请多加点分数-51 in lcd to achieve single-chip zlg gui, I hope more good points scores, please

此源码利用单片机模拟实现IIC总线通信，可以连接基于I2C的硬件调试 -use of this source SCM simulation IIC bus communication, based on the I2C can be connected to the hardware debugging

4x5的键盘扫描,一个实用的单片机键盘程序-4x5 keyboard scanning, a practical single-chip microcomputer keyboard procedures

基于ATmega8的数控电源 包括显示 扫描 转换等详细的源程序-NC-based ATmega8 power, including details such as display scan conversion source

TIMERDEMO for arm7 ,学习用，认真阅读后再根据自己需要更改！-TIMERDEMO for ARM7, to study, read carefully before According to their own needs change!

可驱动8/16位数码管显示或64/128只独立LED 的芯片BC72811A中断编程。BC7281A只占用单片机3个I/O口-can drive 8/16 Digital Display or 64/128 only independent LED chip BC72811A interrupted programming. BC7281A only occupies three microcontroller I/O port

51联合adc0804测电压程序。可以测0`5V电压,精确到千分位4位数码管显示。-51 Joint adc0804 voltage measurement procedures. 0 `5V can be measured voltage, accurate to four spaces per thousand digital tube display.

公交车IC卡电路图程序 希望能帮助大家-Bus IC card circuit procedures

本程序将指定的显示缓冲区送显，并将读取的键值送显。 入口参数：显示缓冲区首地址在SADR中,要显示的位数在CNT中。 出口参数: 无。-This procedure will be sent to the designated display buffer significantly, the key will be sent to a significant reading. Entrance parameters: the first address in the display buffer SADR, it is necessary to show that the median of the CNT. Export parameters: None.