DS1307 RTC 使用 8051 通过 I2C 协议

报警产生器,有详细的C语言代码，还有详细的电图，可通过PROTEUS仿真。-Alarm Generator, has a detailed C language code, there is a detailed electrical diagram, through the PROTEUS simulation.

是基于FPGA的光栅尺辩向程序设计！使用的是quartes II开发软件！-FPGA-based optical grating to the program design debate! Using quartes II development software!

此程序为ds18b20温度采集芯片的keil c 程序没有加入显示的部分,但已调试过.可用-This procedure for collecting chips DS18B20 temperature keil c program not joined the show part, but have been debug. Available

IAR环境下 LPC2478 AD程序-IAR environment LPC2478 AD programs

MGLS-240128TA液晶点阵显示驱动程序-MGLS- 240128TA dot matrix LCD display driver

用lpc2114，控制max1241ad芯片及串口的源码。开发环境为ads1.2，io接法在宏定义里。-With lpc2114, control and serial max1241ad chip source. Development environment for ads1.2, io connection the macro definition.

周立功easyarm2200平台第5章试验代码-Ligong-easyarm2200-week-test-platform-code-Chapter-V

应用背景 VB写的控制程序，通过PC端上位机控制，在电路板上实现相应的演示效果。  VB write control procedures, through the PC side of the upper computer control, on the circuit board to achieve the corresponding demonstration effect. 关键技术首先 烧写程序到单片机   晶振 11.0592MHZ连接好串口线打开上位机软件 选择好COM端口  设置波特率为9600 First of all burn to write programs to chip crystal 11.0592Mhz serial line connection open PC software select the COM port to set the baud rate of 9600

AD7799 source code. AD7799 is interfaced with 8051 controller using SPI.

C语言规范,在写程序可以避免一些不必要的错误-C language specification, in the writing process to avoid unnecessary mistakes