使用c51单片机制作的气象五要素采集程序 包括DS1302温度以及TLC2543、24c04，键盘 240*320液晶模块！...

DS18B20温度采集和输出显示程序，用汇编语言实现-DS18B20 temperature acquisition and display program output, using assembly language to achieve

秒表C51程序，包含键盘扫描， 在数码管上显示各个数字， 使用80C51单片机-stopwatch C51 procedures, keyboard scanning, digital control in the various figures show that the use of 80C51 microcontroller

1602字符型液晶屏的c51驱动程序,详情见文件-1602 character LCD screen c51 driver, as detailed in the file

使用avr90can32双串口传输蓝牙数据-Avr90can32 dual-use Bluetooth serial data transmission

在at89c51上实现webserver-AT89C51 achieved in the webserver

采用单片机控制的cs8900芯片的驱动和TCPIP协议栈-using micro-controller chip the cs8900 drive and TCPIP stack

《51系列单片机高级实例开发指南》一书的can总线的PC端的源代码-"51 MCU Development Guide Senior example," a book can Bus PC side of the source code! !

用keil51开发的7219程序实现led显示-7219 with the development of procedures keil51 realize led display

利用动态扫描和定时器1在数码管上显示 出从765432开始以1/10秒的速度往下递减 直至765398并保持显示此数，与此同时利 用定时器0以500MS速度进行流水灯从上至 下移动，当数码管上数减到停止时，实验 板上流水灯也停止然后全部开始闪烁，3秒 后（用T0定时）流水灯全部关闭、数码管上 显示出"HELLO"。到此保持住。 设晶振频率为12MHz。-The use of dynamic scanning and Timer 1 in the digital control to show from the beginning of 765,432 to 1/10 seconds until the speed of descending down 765,398 and maintain display this number, at the same time the use of Timer 0 to 500ms the speed of light from the flowing water to Under the move, when reduced to a few digital tube stop, the experiment on-board water stop and then all the lights started to flicker, 3 seconds later (T0 regularly used) closed water lights, digital tubes show

此程序为飞思卡尔智能车校内选拔赛主控为STC51单片机的初始程序-This is a smart car in schools Freescale trials STC51 SCM control for the initial procedure