单片机78P156

MSP430FG43x系列单片机汇编源代码-MCS MSP430FG43x source code compilation

一个不错的硬盘播放器程序,包含VFD显示程序,红外线遥控程序,硬盘读写程序,及解码程序等.-a good hard disk player procedures, including procedures VFD, infrared remote control procedures, hard drive read and write procedures and decoding procedures.

STC89C58RD +宏芯（driver）驱动TOPPTFT_LCD-STC89C58RD+ Macro-core (driver) driver TOPPTFT_LCD

字符液晶显示驱动程序，用c语言编程，具体功能见程序。

系统以AT89S51单片机为核心，利用单片机可根据实际的需要随时更改程序而实现功能的改变。包含程序和课程设计文章-AT89S51 microcontroller system to the core, the use of single-chip microcomputer according to actual need to change procedures and the achievement of functional change. Contains the procedures and curriculum design articles

非接触式无线巡更系统实现讲解，希望能给大家带来帮助-Non-contact wireless realize on Patrol System, I hope everyone can help

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

步进电机的单片机控制，可以在Proteus下进行仿真-Stepper motor microcontroller control, can be carried out under the Proteus simulation

pic 16系列单片机内部ad使用 实在16f716上使用的 f72也可以用。-pic 16 series microcontroller 16f716 internal ad used to use it can also be used f72.

松翰单片机开发包，方案适用于成本低的产品开发 -SONIX microcontroller development kits, the program applies to low-cost product development