PIC18F4431的电机控制程序,交流马达例程

电机不转，按下启动键，电机旋转，速度为25转/分，按下加1 键，速度增加，按下减1 键，速度降低，最高速度为100 转/分，最低转带为25 转/分，按下停止键，电机停转。速度值要求在数码管上显示出来。-Motor does not turn, press the start button, motor rotation speed of 25 rev/min, press the 1 key, the speed increase by 1 press the button to lower the speed, the maximum speed of 100 r/min, with a minimum of 25 to r/min, press the stop button to stop motor. Speed value of the requirements in the digital tube display.

EEPROM读写程序: 先向EEPROM写入一幅图片数据，然后从EEPROM中读取，并在128*64显示屏显示出来。-EEPROM read and write procedures: first EEPROM write a piece of picture data, and then read from EEPROM, and 128* 64 screen is displayed.

51驱动RA8835/SED1335的320*240的液晶驱动程序-use 51 to driver LCD display in scale 320*240 with RA8835/SED1335

超级单片机开发软件组合,希望对单片机初学都有用-Super single-chip software portfolio, and they hope to have a single-chip learning with

采用AT89C51单片机进行编写，步进电机端口:P1.0,P1.1,P1.2,P1.3,遥控器接口p3.2喇叭p3.7-AT89C51 single-chip microcomputer used for the preparation, stepping motor port: P1.0, P1.1, P1.2, P1.3, remote control interface P3.2 Speaker p3.7

单片机简易频率计。包含有Proteus仿真程序-Simple single-chip frequency counter. Proteus simulation program contains

UARTDemo使用UART中断方式进行通讯的范例-UARTDemo use UART interrupt communication paradigm

sd 卡驱动软件包: SD卡物理层 ---- SD卡SPI模式支持的命令-sd card driver package: SD Card Physical Layer SD cards support SPI mode command

嵌入式TCP/IP协议栈。 C 源码，对于开发TCP/IP协议栈的用户具有非常大的参考价值。-embedded TCP/IP protocol stack. C source code for the development of the TCP/IP protocol stack users with a great reference value.

2410电机驱动，ADS编译，测试没问题对触摸屏有兴趣的初学者可以用-2410 motor drive, ADS compiler, testing is no problem on the touch screen are interested in the beginners can use