周立功的EazyARM2200的模板，里面还有ucos的模版，还有ARM和Thumb两种模式下的模版...

在C51上显示四个数码管程序，简单易懂，试用过-In the C51 display four digital control program

A/转换程序，用在8051或8031，此外还有两个小的显示的程序-A/switching procedures used in 8051 or 8031, in addition to two small display procedures

在keil-ARM环境下对ARM7处理器编译成功的I2C总线程序，程序通过I2C总线向UART串口发送数据，验证了I2C总线程序的正确性。-Keil-ARM in the circumstances of the ARM7 processor to compile the success of I2C bus procedures, procedures for the adoption of I2C serial bus to send data to the UART, I2C bus to verify the correctness of the procedure.

C8051F020的KEIL工程文件，包括一些内部资源使用代码，以及TS19264的驱动程序-C8051F020 KEIL project, including some internal resources to use code, as well as TS19264 drivers

这是在matlab中的先进pid源程序，可以通过它学习pid控制-This is a matlab advanced pid source, you can learn through its pid control

ppt文件，介绍了瑞萨公司的主要嵌入式系统产品系列，以及M16C单片机的性能指标与结构特点 -ppt files, introduced the company s principal Renesas Embedded Systems product line, as well as the M16C MCU performance and structural characteristics

51实现ADC的源程序， -51 realize the source ADC,

系统can地址为550,用于can系统测试,应用T0定时器每隔1s向can总线发送一组数据:数据长度为8个字节, 首字节为05H,第二个字节为累加变量,每秒钟数值增加1,-system can address 550 for the test system can, Application T0 1s to every timer can send a bus of data : data length of 8 bytes the first byte of 05H, the second byte of cumulative variable, an increase in value per second.

PHILIP驱动器PCF8576驱动程序，可驱动4×40个点-PHILIP drive PCF8576 driver can drive 4 × 40 points

凌阳61板单片机应用，用到两块61板和一块以太网模组，模组和一块61板实现以太网驱动，另一块61板实现音频播放及辨识-Sunplus 61 plate SCM application, used two plates and a 61 Ethernet module 61 modules and a plate Ethernet driver and the other a 61 plate achieve literacy and Audio Player