使用单片机C8051F330对无线发射接收模块进行配置与控制,使组件成为无线通讯中的终端,可与基站进行双向通讯-C8051F330 use single-chip wireless transceiver and control module configured to enable wireless communications components to become the terminal, with the base station two-way communication

采样C语言编写的128×64分辩率的汉字液晶显示驱动程序-C language sampling of 128 x 64 Resolution of the Chinese LCD Driver

spi 翻译资料 7.2 SPI总线 SD卡信道由指令和数据位（起始位和结束位）组成，SPI信道由字节定向。 每一个指令或数据块由8位的字节和CS标志构成。类似SD卡协议, SPI通讯由 指令、响应和数据组成。全部的主机与SD卡之间的通信由主机控制。主机执行 每一跟CS标志为低的总线-spi Translation 7.2 SPI bus data channel from the SD card command and data bit (start bit and end bit) component, SPI channel directed by byte. Every command or data block from 8-bit bytes and CS constitute signs. SD card similar to the agreement, SPI communications from command, response and data components. All of the host and the communications between the SD card by the host control. Each host implementation with CS low marks for bus

一个电子产品开发时的部分c代码B!绝对能用!-When an electronic product development part of c code B! Absolutely can!

单片机定时器的应用，通过对专用寄存器的设定，完成定时计数功能！-Application of single-chip timer, by setting a dedicated register, complete the count function from time to time!

Atmel Atmeag128 AVR弹片机 随书原码

利用AT16的A/D转换功能,测量两点电位差-AT16 use the A/D conversion function, measurement of potential difference to two points

串口控制8路舵机程序,本程序适用于III型实验板，如有需要请与我联系-Serial 8-way steering control procedures, this procedure applies to type III board and, if necessary, please contact me

STC单片机利用XBEE 模块发送数据。 18B20采集温度。-STC Singlechip send data using XBee modules. 18B20 collection temperature.

CC1020RF芯片与TI单片机接口程序，C语言-CC1020RF chip with the TI single-chip interface program, C language