spi 翻译资料 7.2 SPI总线 SD卡信道由指令和数据位（起始位和结束位）组成，SPI信道由字节定向。 每一个指令或数据块由8位的字节和CS标志构...

万年历代码，在凌阳61单片机调试通过。 万年历代码，在凌阳61单片机调试通过。-Calendar code, in 61 single-chip debugging through Sunplus. Calendar code, in 61 single-chip debugging through Sunplus.

avr m128 双串口通讯,实现数据的转发功能,晶振为11.0592MHz,波特率为96-avr m128 dual serial communications, data forwarding function, crystal for 11.0592MHz, baud rate of 96

使用MSP430f247芯片内的ADC12模块实现单通道动态采集外部电压-MSP430f247 chip using the ADC12 module realize single-channel dynamic collection of external voltage

单片机在使用KEIL调试时如何在STARTUP.a51里设置寄存器的源码.-Single-chip debugging using KEIL how STARTUP.a51 installed in the source register.

VB与S7200的PPI通信-VB and the PPI communications S7200

自动交通管理系统 用红、绿、黄三支共两组发光二极管表示交通信号灯，利用单片机模拟有时间显示的定时交通信号灯控制管理。信号灯的变化规律可如下： 1）放行线：绿灯亮放行25秒，黄灯亮警告5秒，然后红灯亮禁止。 2）禁止线：红灯亮禁止30秒，然后绿灯亮放行。 3）当某一方向的红灯亮时，若该方向有车通过，则用扬声器声报警。（撞红灯信号可用3-5V模拟量表示） 同时用2位数码管进行30秒钟递减时间显示。-automatic traffic management system using red, green, yellow a total of three light-emitting diodes, said two traffic lights, using SCM time simulation shows the regular traffic signal control. Signal changes in the law to be as follows : 1) Release Line : green clearance 25 seconds, bright yellow warning five seconds, and then the red-ban. 2) prohibit the lines : red-Ban 30 seconds, then green clearance. 3) When the red light in one direction- that if the direction of a car passed, the use of loudspeakers sound alarm. (Red light signals can hit 3- 5V analog said), while using two digital tube for 30 seconds decreasing time displayed.

单片机做的LCD划线，学单片机的好资料，proteus仿真通过，学习的好资料-Single-chip LCD line to do, learning good information on SCM, proteus simulation adoption, learn good information ...

单片机51系列的122*32的某液晶驱动程序-MCU Series 122 51* 32 in a LCD driver

学习型红外遥控开关( C51语言源程序)-learning infrared remote control switch (C51 source)

基于SPCE061电子竞赛―数字化语音存储与回放-SPCE061 electronic-based competition- Digital Voice Storage and Playback