采样C语言编写的128×64分辩率的汉字液晶显示驱动程序

单片机控制AD2543,同时通过液晶显示的程序，通过移植修改即可以应用-SCM AD2543, at the same time through the liquid crystal display procedures, through the graft modification can be applied

THE USE OF74LS164 74LS164 74LS164 -THE USE OF74LS164 74LS16474LS16474LS16474LS164

直流电机的单片机控制，可以在proteus下进行仿真-DC Motor Control MCU

一个很不错的按键单片机C程序-a very good button SCM C Program

收音机程序，大家分享一下吧！！！！1 大家也帮忙看看写的对不对-VIODE

针对51单片机的中断触发按键的程序，利用P3.2口接行列按键。-For 51 single-chip key interrupt to trigger the process, I then use the ranks of P3.2 button.

用并口通信时,只需发送仿真软件的十六进制显示窗口的第四个字节后的所有数据。 如:清全屏的十六进制显示窗口是55AA0001434C42,采用并口通信时只需发送434C42-with Parallel Communications, only this simulation software hexadecimal display window of words, after the data. Such as : a full-hexadecimal 55AA0001434C42 show window is used and only parallel communication sent 434C42

vb串口通信调试,能够进行16进制和字符的数据传输。-vb serial communication debugging, can be 16 hexadecimal and character data transmission.

可用于 51系列单片机与触摸屏之间的通讯 （一般用modbus实现通讯）-design for exchange massage both mcu51 and torch pad

C51温度检测与报警的设计，带Proteus仿真-C51 temperature detection and alarm design, simulation with Proteus