16x2 character LCD Driver for C language source code experiment that absolutely...

nrf9e5的天线pcb,我找了好久的,可以直接开板-nRF9E5 antenna pcb, I am looking for a long time, and can directly open board

这是一个延时程序，经常用于函数效果时使用，做到一个延时效果，让用户感觉效果真实-This is a time delay procedure, often used for function results, so that a delay effect, allow users to feel the real effect of

IAR例子，里面是一个完整的定时例子。包含Proteus电路图。-IAR example, which is a complete example of the timing. Include Proteus schematic.

串口扩展,又一个UART扩张成为五个,GM8125驱动程序-Serial port expansion, another five become UART expansion, GM8125 Driver

很好的移动数字电视方案,LCD显示器显示图象.-A very good mobile digital TV solutions, LCD monitors display images.

1．熟悉硬件仿真工具KD30的使用。 2．修改样本程序 SAMP1a，使无论在计数或停止计数时，按 SW3 均对计数值清零，并停止计数。 3．编制一个秒表程序, 测试精度为0.1秒，按 SW1键启动计数，再按一次 SW1键停止计数。任何时候按 SW3 键停止计数，并对计数值清零。 4．按 SW1键后， 以 0.1 秒为单位开始计数，再按一次 SW1 键停止计数。若按 SW1 键时间超过2秒，则计数值清零，回到初始状态。-1. Familiar with the hardware simulation tool KD30 use. 2. Revised procedures SAMP1a samples, regardless of the count or counts at the end, according to SW3 numerical terms were right, reset, and stop counting. 3. Preparation of a stopwatch procedures, testing accuracy of 0.1 seconds, according to bond SW1 start counting, according to a key SW1 stopped counting. By SW3 any time to stop counting bond and reset the count. 4. By SW1 bond, after 0.1 seconds for start counting, according to a key SW1 stopped counting. If SW1 keys by the time more than two seconds, then reset the count and return to the initial state.

pwm改变占空比的程序，已调试过，可以直接用KEIL使用-pwm duty cycle to change the procedures have been debug, and can be directly used by KEIL

ad0804程序，可实现ad转换，显示，-ad0804 procedures can be realized ad conversion, display,

Pic18F458的Can通信模块代码 -Can communication module of PIC18F458 code

自己写的ATmega16单片机驱动1602液晶的头文件，本人已测试通过，不错！-himself wrote the ATmega16 LCD Driver 1602 for the first document, I have been tested, yes!