8*8点阵led显示功能介绍，包括点阵构成的原理，显示一竖柱，显示一横柱...

此源码利用单片机模拟实现IIC总线通信，可以连接基于I2C的硬件调试 -use of this source SCM simulation IIC bus communication, based on the I2C can be connected to the hardware debugging

CF卡的驱动编程,含有CF卡驱动的介绍,是入门的好资料.-CF card-driven programming, which contains the introduction CF card driver is a good data entry.

lcd显示keil源码-lcd demonstrates the keil source code

在LED上显示中文汉字的源代码，采用汇编语言，对于入门者帮助很大。-LED display Chinese characters in the source code, using assembly language is very helpful for beginners.

基于at89c2051的方波发生器，MAIN: MOV SP,#60H 设置SP指针 MOV R0,#50H 显示缓冲区首地址时50H ML0: CLR A MOV @R0,A 显示缓冲区清零 INC R0 CJNE R0,#55H,ML0-AT89C2051 based on the square-wave generator, MAIN: MOV SP,# 60H Set SP pointer MOV R0,# 50H shows that the first address buffer 50HML0: CLR A MOV @ R0, A display buffer cleared INC R0 CJNE R0,# 55H, ML0

atmega16L输入捕获经典试验已经通过验证-atmega16L input capture classic trials have been validated

此程序是液晶与数码管的结合.是初学者必须掌握的.可以为以后写综合程序有所帮助-This procedure is LCD with a combination of digital tube. Is a beginner must master. Can be written comprehensive procedures for future help

用过采样和求均值技术提高模数转换器的分辨率.pdf-----针对目前单片机内嵌的模／数转换器的分辨率太低，而外接高分辨率成本又太高的情况，提出了用“过采样和求均值”的技术来使在有用的测量频带内的信噪比得到改善，从而提高测量的分辨. 率。并利用 60 - 7 0 /对其结论进行仿真，且在单片机上予以实现，结果表明测量分辨率明显提高。-Sampling and averaging techniques used to improve the resolution of ADC. Pdf----- targeted at the embedded microcontroller A/D converter resolution is too low, while the external high-resolution costs are too high situation, put forward with " Oversampling and Averaging" technology to make useful measurements in the frequency band signal to noise ratio to be improved, thereby enhancing the measurement resolution. rate. And a 60- 7 0/simulation of its conclusions, and in the SCM to be achieved, results show that the measurement resolution has improved significantly.

编译为ICC AVR6.25A ATMEGA16L芯片 ad转换-Compiled for the ICC AVR6.25A ATMEGA16L chip ad conversion