自己动手制作一个MCS

最小二乘法拟合用在嵌入式系统的代码,单片机上可以测试过-Least square method used in embedded systems code, single-chip can be tested

LT_1B msp430开发板例子程序－TB3

液晶驱动程序,提供通用液晶驱动的框架,可以嵌入各种操作系统,提供了向上的接口-LCD drivers, LCD drivers provide a common framework that can be embedded in a variety of operating systems, provides a progressive interface

本软件是单片机通讯的主程序，通过串口传送数据。-This software is the main single-chip communications, through the serial transmission of data.

模拟交通灯，并带有数字显示的程序。初始时全为红灯，显示“HELLO”字样。然后交通灯以“红绿、红黄、绿红、黄红”四种状态做循环，而且黄灯会闪烁，每种状态都带有到数记时。当按下P3_2时，变成“红红”状态，并显示“STOP”字样！ -simulated traffic lights and figures with the procedure. When all of the initial red, shows that the "hello" words. Then traffic lights to the "black, red and yellow, green, red, yellow red" state to do four cycle, but the yellow light flashes, each state will have a few to remember when. When pressed P3_2, into a "red" state, and shows that the "STOP" word!

51单片机驱动GSM模块（WaveCom Q2403A）C语言源码-51 GSM module (WaveCom indoor) C language source code

AVR 简介，介绍AVR单片机的原理，应用及编程过程。-AVR description

这是LCD1602与msp430之间的通信,其实可以直接从51移植过来,但是一定要在硬件加上拉电阻,要不然是不通不过的,我说的是你用的是5V的LCD-This is the LCD1602 and communication between the MSP430 can in fact be a direct transplant from the 51, but must be coupled with pull-up resistor in the hardware, otherwise it is unreasonable, however, I say is that you use the LCD is 5V

通过串口，接收上位机发送的命令，并进行CSI24WC02的读写操作，并返回相应 数据或应答。用汇编实现,可以用keil编译器-through the serial port, the receiving PC to send orders, and CSI24WC02 read and write operations, and return to the corresponding data or response. Assemble realized, can be used Keil compiler

AT89C51SND1C方案mp3资料 AT89C51SND1C方案mp3资料-AT89C51SND1C program mp3 program mp3 information AT89C51SND1C mp3 information AT89C51SND1C program information