mega8 electronic clock.

本程序给出了一种msp430单片机模拟实现i2c总线的一种方法-this procedure gives a MCU Controller Simulation i2c a method Bus

单片机时钟芯片DS1302的控制程序，还有液晶的驱动-Single-chip clock chip DS1302 control procedures, as well as LCD driver

T6963为控制芯片的液晶驱动程序，带proteus方针。-For the control of the T6963 LCD driver chip, with Proteus approach.

用C8051F060开发的光功率计 由C51编写的程序-Optical Power Meter with C8051F060 development program prepared by the C51

parameters of model induction motor

基于盛群单片机开发的 获得温湿传感器dht11和光敏电阻的数据 并且发送到1602显示屏的程序-Holtek-based single-chip temperature sensor was developed and photosensitive resistance dht11 and sent to the data display process 1602

在软件proteus下仿真MCU-51单片机6位LED计数器的演示例子和完整源代码(keil工程)-in software simulation under MCU-51 6 LED counter demonstration examples and complete source code (c51 engineering)

关于传感器的程序，请各位大侠给予指导，等-Procedures on the sensor, please heroes for guidance, etc.

HT93LC46EEPROM 是Holtek 制造的1K 位系列的EEPROM（电子可擦除只读存储器），一般 它用于微控制器的固定数据的存储。在本文中，我们将以Holtek 公司8 位微控制器HT49 系列为例，介绍该芯片常用的操作功能代码。用户只需把代码加到程序中，并且在使用HT93LC46 之前将引脚CS/SK/DI/DO 连接即可。-HT93LC46EEPROM is a 1K-bit Holtek manufactured series of EEPROM (electronic erasable read-only memory), general micro-controller is used to store fixed data. In this article, we will Holtek" s 8-bit microcontroller HT49 series, for example, the introduction of the chip code commonly used operating functions. Users simply add the code the program, and before the use of HT93LC46 pin CS/SK/DI/DO connection is needed.

基于80C51单片机源码公开的Small RTOS 1.12.1版-80C51 microcontroller based on the open source version 1.12.1 Small RTOS