Replant J1939 Codes and ucOSII On the Freescale 16 bit MCU(Mc9s12dp256).

专用看门狗芯片5045的单片机C语言驱动程序-Dedicated watchdog chip 5045 microcontroller C language driver

C0851F020单品机DA转换源码，带液晶显示的功能-C0851F020 single source goods machine DA converters with liquid crystal display function

仅供参考 仅供参考-only reference is for reference only reference is for reference only

小弟最近才写过的一款无刷电机的单片机驱动C程序，已经测试过可行。程序不是很复杂。-Younger brother recently wrote of a brushless motor-driven single-chip C procedures have been tested feasible. Process is not very complicated.

ＣＡＮ协议标准设计规范（电梯项目080716）.docＣＡＮ协议标准设计规范（电梯项目080716）.doc-CAN protocol standard design specifications (elevator project 080716). DocCAN protocol standard design specifications (elevator project 080716). Doc

一款非常实用LCD16*2 液晶程序(时钟程序).仅供大家学习参考用-LCD16* 2 LCD (clock procedures). We only used to learning

avr单片机atmega8系列定时器的使用测试程序，本程序为示例程序，适用于初学者 -avr SCM timer atmega8 series of testing procedures, the procedures for sample procedures applicable to beginners

红外通信程序，在集中器采集器电表和手持终端及主台通信中有很好的运用-Infrared communication procedures, the concentrator meter collector and handheld terminals and main-Taiwan communications have a very good use

智能车的马达控制程序,通过串口控制车的加速减速等。-This file is for Motor of Intellengence Car.

P1.7～P1.0接发光二极管L8～L1，要求利用单片机内部定时器1，按方式1工作，每0.01秒T1溢出中断一次。要求编写程序模拟时序控制装置。开机第1秒钟L1、L3亮，第2秒钟L2、L4亮，第3秒钟L5、L7亮，第4秒钟L6、L8亮，第5秒钟L1、L3、L5、L7亮，第6秒钟L2、L4、L6、L8亮，第7秒钟8个发光二极管全亮，……一直循环下去。fosc=11.0592MHz-P1.7- P1.0 then LED L1 to L8, by using a timer internal microcontroller, a work by the way, every 0.01 seconds T1 interrupted an overflow. Simulation prepared timing control device. Boot 1 seconds L1, L3- liang, two seconds L2- L4, L5 three seconds, L7- liang, 4 seconds L6, L8-liang, 5 seconds L1, L2, L5, L7- liang, 6 seconds L2, L4, L6, L8- , 7 seconds 8-LED whole ... has been the cycle continues. 11.0592MHz fosc =