Development environment, the use of ads 1.2 Developer Edition s3c2440 array usin...

电机不转，按下启动键，电机旋转，速度为25转/分，按下加1 键，速度增加，按下减1 键，速度降低，最高速度为100 转/分，最低转带为25 转/分，按下停止键，电机停转。速度值要求在数码管上显示出来。-Motor does not turn, press the start button, motor rotation speed of 25 rev/min, press the 1 key, the speed increase by 1 press the button to lower the speed, the maximum speed of 100 r/min, with a minimum of 25 to r/min, press the stop button to stop motor. Speed value of the requirements in the digital tube display.

1602 液晶 在任意位置显示字符 数字 使用的是新华龙单片机 100脚 的 -1602 LCD display characters in any number of locations using a new single-chip 100-pin of Hualong

一个用ATMega88来实现一key键和一个Rotor的代码，可能过UART上传数据。-A key with ATMega88 to achieve a key and a Rotor code, may be to UART upload data.

LT_1B msp430开发板例子程序－TA4

单片机控制步进电机启动停止，正反转以及转速。proteus+keil.(由于大小不够，还加入了RS485在单片机多机通信中的应用，用到RS485接口芯片max487)-keil+proteus+motorstepper

51单片机对AT45D041卡（大容量IC卡）的读写程序 把.rar改成.c即可-51 micro AT45D041 card (large-capacity IC card) reading and writing procedure. Rar changed. C can

8051的测控问题分析，有A/D、D/A、开关量接口-8051 Analysis of the telemetry, A/D, D/A, Switch Interface

msp430单片机控制输出PWM波,可以用来控制DC_DC变换用的控制信号,很好用-MSP430 single chip microcomputer to control the output PWM waves, can be used to control DC_DC transform the control signals used, very good use

16分钟语音芯片ISD4004操作的C51源程序，自己调试通过的！-16 minutes of voice chip ISD4004 operated source C51, adopted its own debugging!

一个基于MCS-51的单片机监控程序，并附带上位机程序，也是用C语言编写的。-one based on MCS-51 microcontroller control procedures, and procedures incidental PC, as well as using the C language.