4 位计数器

ks8695网络处理器资料汇编。-ks8695 network processor compilation.

在PXA270主板上，配置完基本的GPIO后，可以用本程序读写CF卡来测试CF插槽的硬件连线-The motherboard in PXA270, finished basic GPIO configuration, you can use this program to read and write CF slot CF card to test the hardware connection

开发环境为uClinux2.4.x+s3c44b0。此程序以字节方式对IIC器件进行读写。通过硬件测试，可以直接使用。附：IIC测试程序。具体使用说明见其中的readme.txt。-development environment for uClinux2.4.x s3c44b0. This procedure in byte pairs IIC device reading and writing. Through hardware testing can be used directly. Report : IIC test. Specific use see the readme.txt.

TMS320 DSP_BIOS User‘s Guide-TMS320 DSP_BIOS User

1）LPC2148开发。开发板是由NEX机器人。链接：http://www.nex-robotics.com/lpc2148-development-board/lpc2148-development-board.html  2）GPS模块：联发科MT3318芯片组的模块链接：  http://www.nex-robotics.com/products/gps-receiver/gps-receiver-mt3318-module.html  3）加速度：MMA8451Q（3轴+/-8克I2C基于加速度传感器飞思卡尔）链接：  http://www.nex-robotics.com/products/sensors/3-axis-digital-accelerometer-with-voltage-regulator.html  4）GSM调制解调器：SIMCOM SIM900a链接：  http://www.rhydolabz.com/index.php?main_page=product_info&products_id=1079

USB鼠标的设计资料（电路图，程序，说明文章）-USB mouse design data (schematics, procedures, how-to articles)

本程序能够在没有操作系统下可以测试LCD的驱动，在LINUX下和WINCE下都可以根据这段程序里面的寄存器设置进行驱动程序的编写！-This procedure can in the absence of operating system you can test LCD driver in under LINUX and WINCE under this procedure can be the basis of the register inside the driver settings to prepare!

64X16点阵的PROTUES仿真,六种显示效果切换,对点阵爱好者有很大的研究价值,拿来分享-PROTUES the 64X16 lattice simulation shows that the effect of the six switch matrix lovers of great research value, used to share ...

电子钟或万年历程序，很实用的，有闹钟，年、月、日等-Electronic clock or calendar program, it is useful, there is an alarm clock, year, month, date, etc.

S3C4510B的一些开发例程，对入门ARM处理器有绝对的帮助-development example of S3C4510B,help to learning ARM processor programmer.