msp430 microcontroller data sheet suitable for beginners, want to be helpful for...

CSP封装技术,最新IC封装技术.--CSP packaging technique, the latest IC packaging technique.

应用背景88E6095是现在很少用的交换机芯片，本源码有很多关于phy寄存器的例子，也有驱动这个芯片的例子   关键技术 对于刚进入嵌入式学习的朋友很有帮助，都是交换机的配置

ARM COrtex CMSIS interface example

富士通单片机LIN-uart及uart实验程序源码。-Fujitsu MCU and LIN-uart source code uart experimental procedure.

该源程序能够实现步进电机的各种运动功能并伴随着相应的LED输出-The source code can achieve a variety of stepper motors and motor function accompanied by a corresponding LED output

这是一个RC500的开发实例，我想对于想从事RC500开发的人来说极为有帮助的-RC500 This is an example of the development, I would like to wish to engage in RC500 for the development of the very people who help

用于无感无刷直流电机调速的电子调速器驱动程序。基于ATmega8单片机，使用C语言开发，此版本是基于MK电调程序最新版本0.42开发。源程序分为电调上电自检，电机启动，反电动势过零检测，IIC、PPM、串口信号接收，电流测试，电调地址设定等功能。是一个完善可以的电调驱动程序。

crc－ccitt校验原理及编程实现，硬件采用ＦＰＧＡ实现ＣＣＩＴＴ校验．-usefull material for crc check ,including the funcion of crc and program.

本程序是显示模块的例程，所接器件为四位八段led数码管，其中PTB0-PTB3 与数码管的位选相连接，PTB4，PTB5与74LS164连接确定你开发板上拨码开 关JP1（图片上的12）的两位和JP4（图片上的9）的5、6、7、8位处于on）， 而其他位处于远离on！-This procedure is the routine display module, the access device for four eight led digital tube, which PTB0-PTB3 bit digital tube and connected to the election, PTB4, PTB5 with 74LS164 sure you connect the development of on-board DIP switch JP1 ( picture on the 12) two and JP4 (picture on the 9) of 5,6,7,8 located at on), while the other located at far away from the on!

ADS下烧写flash的文件-ADS under the flash of burning documents