采集数据后处理程序。在MS51单片机上可直接拷贝应用。

BasicCAN 驱动程序-BasicCAN Driver

I2C接口AD转换器ADS11XX的应用，c51原代码调试通过，放心使用。-I2C interface AD converters ADS11XX application decoder source code debugging through reassured use.

l298调 速 程 序 常规的接法是这样的，EnableA接PWM信号，Input1输入正反控制信号， Input2是Input1经过反相以后的信号。L298的电平是与TTL电路相兼容的，一般是超过2.5V就为高电平。假如Input1为高电平时电机正转，那么低电平时就是反转，PWM信号控制电机的转速。 _________________ -l298 procedures conventional speed connection that is the case, EnableA then PWM signal, Input1 input positive and negative control signals, Input2 is Input1 through after RP signal. L298 level is compatible with TTL circuits, and is generally more than 2.5V for the high. If Input1 is high when the motor is transferred, then that is when low-level inversion, PWM signal to control motor speed. _________________

16乘2的液晶显示屏演示程序，对于研究液晶屏很有帮助

C51编写的1602液晶片驱动程序，是C语言编写的！-C51 prepared by the 1602 film LCD driver is prepared by the C language!

Thumb ARM Interworking Image for lpc-ARM Thumb Interworking Image for lpc

当按下开关SP1，AT89S51单片机产生“叮咚”声从P1.0端口输出到LM386，经过放大之后送入喇叭。 -When pressing the switch SP1, AT89S51 Single-chip a " ding dong" sound from the output port P1.0 to LM386, after amplification into speakers after.

at24c64驱动 开发环境 iar 芯片 atmega169-iar-driven development environment at24c64 chip atmega169

LCD液晶显示驱动模块液晶显示驱动单片机源程序-LCD display driver module LCD driver single-chip microcomputer

采用单片机控制的cs8900芯片的驱动和TCPIP协议栈-using micro-controller chip the cs8900 drive and TCPIP stack