Stepper motor control, c version, proteus simulation

用DSPIC完成高通滤波器的设计，无疑是经济实惠的方案-DsPIC complete with high-pass filter design, is cost-effective program

Medwin v2.39,51单片机开发利器-Medwin v2.39, 51 MCU Development weapon

c51控制1602液晶显示，适合初学者，硬件测试可用，附含1602液晶说明-C51 control of liquid crystal display 1602 is suitable for beginners, hardware testing is available, with 1602 LCD attached note

这个程序是基于有MMC下的SPI接口驱动程序源代码-This procedure is based on the MMC under the SPI interface driver source code

由VHDL 语言实现的AD0809用的是KEIL环境已经得到验证-By the VHDL language used in the AD0809 is KEIL environment has been tested

Keil C51使用详解,WORD格式,教你学习Keil C51-Keil C51 use Xiangjie, WORD format, to teach you to learn Keil C51

运用凌阳单片机控制家庭电器（通过Internet网络）-use Sunplus SCM control household appliances (through the Internet)

本装置是一个以HT46R71D 为主芯片，配合传感器组成的汽车轮胎气压检测装 置，最终取高三位有效值于LCD 显示，有四种显示单位供切换（Psi、Bar、Kpa、 Kgf/cm2）。本装置仅为参考范例，使用时，为提高准确度，建议多量测些组数 据来构建Sensor Output Voltage - Discharge Time (V-T)表格，并作相应校准。-This device is a HT46R71D-based chips, with sensors detecting vehicle tire pressure devices, and ultimately take the high-three RMS in LCD display, there are four types of display units for switching (Psi, Bar, Kpa, Kgf/cm2). Only reference to an example of the device, when used to improve the accuracy of the proposed多量measured set of data to build more Sensor Output Voltage- Discharge Time (VT) forms, and the corresponding calibration.

单片机中的定时器模块，在CVAVR中已实现。-MCU timer module has been achieved in CVAVR.

4X3键盘扫描以及4位动态LED显示的单片机程序-4x3 keypad scanner and four dynamic LED display single-chip program