DS18B20,单片机,C语言开发,proteus仿真

51开发板调试程序，包括LED驱动接口，串口，AD/DA,EEPROM，蜂鸣器，键盘以及16*2LCD驱动模块，并提供单字节和字符串显示接口-51 development board debugger, including the LED drive interface, serial, AD/DA, EEPROM, buzzer, keypad and 16* 2LCD driven module, and provides single-byte and string display interface

华为的印刷电路板（PCB）设计规范，程序编写规范等-Huawei’s printed circuit board (PCB) design specifications, programming specifications, etc.

串行E2PROM存储器驱动程序，包括I2C接口和SPI接口。-serial E2PROM-driven procedures, including I2C interface and SPI interface.

1024fft用MSP430设计的音频信号分析仪-1024fft design using MSP430 audio signal analyzer

之前看过论坛上有一个C8051和S3530A的通信程序，但我认为很复杂而不具有通用性，我自己写的一个3530通过I2C总线与单片机的通信程序,虽然很短,但是很实用.-Read before the forum have a C8051 and S3530A communications procedures, but I think very complex and not universal, and I wrote it myself a 3530 through the I2C bus communication with the SCM process, although very short, but very practical .

用RC500开发IC卡读卡器的源码函数资料-RC500 development with IC card reader function of the source data

本模拟I2C软件包包含了I2C操作的底层子程序，使用前要定义好SCL和SDA。在标准8051模式(12 Clock)下,对主频要求是不高于12MHz-The simulation package includes I2C bottom I2C operation subroutine, before the definition of a good use of SCL and SDA. 8051 in standard mode (12 Clock), the requirements for the frequency is higher than 12MHz

AT89C52的组合按键识别程序,已经调试成功-AT89C52 combination of keys identification procedures have been successfully debug

红外线IR在单片机中的应用及原理-infrared IR in SCM Application of Principle and

单片机6502 编程实现红外遥控接收-6502 microcontroller programming infrared remote control receiver