进行51单片机主控智能车模块测试时用光电管返回的道路信息控制舵机以一定角度转向。...

单片机液晶界面系统,128*64,整个系统中容易开发-LCD microcontroller interface system, 128* 64, the whole system easy to develop

PIC BASIC Pro Dvelopment Suite

测试过的240128LCD单片机c51显示程序-Singlechip 240128LCD tested C51 display program

320*240LCD液晶显示器，C51编程，内有已调试好的软件-320* 240LCD LCD, C51 programming, which has had good software debugging

keilc程序+proteus+vb+串口调试，非常适合单片机开发的人用-keilc procedures+ proteus+ vb+ serial debugging, very suitable for development with single-chip microcomputer

MODBUS-TCP源码（C + VB）-MODBUS-TCP source (C+ VB)

驱动芯片LM386检测要用keil生成hex再用-Driver IC LM386 detection using keil generate hex reuse

四位LED数码显示驱动管动态扫描驱动单片机源程序-four LED digital display driver Dynamic scanning driver single-chip microcomputer

该实验是在“点到点无线通信实验”的基础上进行开发，节点A 作为发射模块，节点B 作为射频休眠实验的对象，PC 通过串口下达休眠和唤醒的指令给节点B，来实现对射频部 件的唤醒和休眠功能。串口的设置为波特率115200b/s，8 位数据位，1 位停止位，无校验位。-The experiment in the " point to point wireless communications experiment" based on the development and launch of the module as a node A, node B as a test object dormant radio frequency, PC through the serial port sleep and wake-up instructions issued to the Node B, to achieve the right wake-up radio frequency components and the hibernation feature. Serial port baud rate is set to 115200b/s, 8 bits of data bits, 1 stop bit, no parity bit.

单片机对FLASH芯片的烧写,源程序,原理图,PCB图-right FLASH MCU chip burning, source, schematics, PCB plans