Introduce the use of single

这是一篇关于嵌入式系统的LCD液晶驱动程序的资料及源程序-This is an embedded system on the LCD driver and source of information

开机自启动程序，很好很强大的。每次开机都能自己启动此程序。-Boot from the startup procedure, very good very strong. Each boot can start this process themselves.

在8X8　LED点阵上显示柱形，让其先从左到右平滑移动三次，其次从右到左平滑移动三次，再次从上到下平滑移动三次，最后从下到上平滑移动三次，如此循环下去。 -In the 8X8 LED dot matrix display cylindrical, smooth movement from left to right to first three times, followed by a smooth move from right to left three times, once again moving smoothly from top to bottom three times, the last from the bottom-up smoothing mobile three times, so the cycle continue.

单片机入门的好教材-good material

凌阳单片机的语音程序4，供学习凌阳单片机的学习者参考-Sunplus SCM four voice procedures for learning Sunplus SCM reference learners

IC卡的模拟！ IC卡的模拟！-IC

通信电源中，整流器模块控制器程序。ATmega16L，8M晶振，使用USART通信中断，使用ADC采集模块数据，使用部分通用I/O口控制模块开关机。-communication power, the rectifier module controller program. Indicator, 8M crystal use USARTs communications interruptions, and the use of ADC data acquisition module, the use of part of general-purpose I/O control module switching machines.

自己写的一个用在单片机串口通讯中的环形队列缓冲区管理模块。-himself wrote a serial microcontroller used in the communications ring buffer queue management module.

ad9851的串行输入控制，用c编写的凌阳单片机程序-AD9851 Serial Input control, with c prepared Sunplus Singlechip procedures

超声波测距 利用 送接受的时间 差计算得到距离-Ultrasonic Ranging acceptable use to send the time difference calculated by the distance