在单片机开发中比较常用的12864液晶屏源程序，c语言的，具有动态显示的。...

欠过压报警电路的设计报告,ICL7100,模拟电路.-Toru 欠压agent changchu forlorn wind chirpy few forlorn rear cavity, ICL7100, Chang Yao-carrying wind.

用汇编写的PIC单片机交通灯程序！配有PROTEUS电路图！-PIC with the compilation of written procedures for single-chip traffic lights! PROTEUS circuit with!

serial函数集 好用-serial Function Set Easy

点阵LCD的驱动原理.绝对的精品.望给初学者以帮助-Dot matrix LCD driver principle. Absolute quality. Look to the beginners in order to help

这是一个tcp 的client 源程序,可以在单片机测试时使用.-This is a tcp source code of the client, you can use single-chip processor.

16*16的LED点阵显示屏资料，资料中还含有proteus仿真的原理图，可以直接打开仿真成功!-16* 16 LED dot matrix display data, the data also contains simulation Proteus schematic, simulation can be directly opened successfully!

此文档是单片机控制的家用饮料快速冷热保温机。。。 -This document is a single-chip microcomputer controlled domestic hot and cold beverages fast machine insulation. . .

单片机课程设计程序，利用单片机模块实现键盘扫描输入输出显示-SCM curriculum design process, the use of MCU module for the keyboard scan input and output display

6段数码管分别显示，时，分，秒，四个按键，K1（P0.0），K2（P0.1）， K3（P0.2），K4（P0.3），四个按键用来调时间的，按下K1，所有位都清零显示，然后按下K2，秒在闪烁，继续按K2分闪烁，不段地按K2 秒--分--时切换着闪烁，在某位闪时按下K3相应位加一，确认调整，按K4，取消调整再按K1。在K1按下以后才有调时的功能，如果K1没有按下，按别的键没有反映。这为了在加点按键功能留着用 -6 respectively of the digital control, when, minutes and seconds, four keys, K1 (P0.0). K2 (P0.1), K3 (P0.2), K4 (width), the four keys to the transfer time, press the K1, All spaces are reset, then press K2, the scintillation seconds, according to K2 pm flickered. not according to K2 of seconds-- minutes-- when switching to flicker in certain press the flash-K3 corresponding increase in a confirmed adjustment by K4, then canceled K1 adjustment. K1 in the press will only be made after the transfer of function, if K1 pressed by other key is not reflected. This points to the function keys used Retention

ds1302 汇编源代码，单片机用的是89c51调试好使-DS1302 compilation of source code, using the 89C51 single-chip debugging so