SCM curriculum design, the use of temperature sensors, through the LCD display r...

又一个LCD1602的例程（主要是最近正在做相关的工作），已经调试通过。-Another LCD1602 routine (mainly related to the work being done recently), have been debugging through.

基于单片机用软件实现直流电机PWM 调速系统-Realize single-chip software-based DC motor PWM speed control system

基于1335的液晶驱动程序2，本全程应用于安得利液晶-1335-based LCD driver 2, the entire liquid crystal used in safety benefit

单片机C语言的上电初始化，这确实是个头疼的问题!-microcontroller on the C language-- initialization, it is indeed a headache!

之前看过论坛上有一个C8051和S3530A的通信程序，但我认为很复杂而不具有通用性，我自己写的一个3530通过I2C总线与单片机的通信程序,虽然很短,但是很实用.-Read before the forum have a C8051 and S3530A communications procedures, but I think very complex and not universal, and I wrote it myself a 3530 through the I2C bus communication with the SCM process, although very short, but very practical .

12位LED的万年历.有源程序和HEX,还有原理图电子时钟日历LED程序-12 LED

/* 程序详细功能介绍： *当按下按键P3.3 ，AT89S51单片机产生“叮咚”声从P3.2端口输出 *程序设计方法 * 1． 我们用单片机实定时/计数器T0来产生700HZ和500HZ的频率，根据定时/计数器T0，我们取定时250us， * 因此，700HZ的频率要经过3次250us的定时，而500HZ的频率要经过4次250us的定时。 * 2． 在设计过程，只有当按下SP1之后，才启动T0开始工作，当T0工作完毕，回到最初状态。 * 3． “叮”和“咚”声音各占用0.5秒，因此定时/计数器T0要完成0.5秒的定时，对于以250us为基准定时2000次才可以。 */-/* Procedure detailed functional Introduction:* When pressing the button P3.3, AT89S51 Singlechip a

avr单片机与flash存储器通信程序,调试通过,希望对大家有所帮助.-avr Microcontroller and flash memory communication program, debug is passed, everyone would like to be helpful.

NOKIA N1600 显示屏全套开发资料,包括原理图,FPC及LDS184的测试程序,需要了解3线SPI的朋友可以参考.-display full development information, including drawings, LDS184 FPC and the testing procedures need to understand three- SPI friends reference.

TI的高性能单片机MSP430+网络控制芯片CS8900A实现数据网络传输-TI"s high-performance network control MSP430 microcontroller chip CS8900A data transmission network