CC1000 RF芯片的初始化及发送程序，C语言

8051单片机串行读写EEPROM，24C02，本案例采用汇编编写。打包成函数，可直接调用。适合初学者学习。-8051 serial read and write EEPROM, 24C02, compilation of the preparation used in this case. Packaged into a function, can be directly invoked. Suitable for beginners to learn.

接单片机8051的经典时钟C程序,包含计时,调时,及闹铃功能-Then the classic 8051 single-chip clock C procedures, including time, transfer time, and alarm functions

英飞凌C166之XC164CS串口通讯程序-Infineon C166

用于单片机4*4键盘扫描，及数码管显示 -muc keybord and led display.

keilc + proteus 并行口设计指示灯实验 要求：掌握80C51单片机输入输出接口使用方法 学会开关量输入输出控制的接口技术及编程方法 实验题目：8个发光二极管D1~D8分别接在单片机P1.0-P1.7端口上，一个开关接在P3.0上。要求输出端口输出 “0”时，发光二极管亮。开关闭合时，开始按P1.0-P1.1-...-P1.7的顺序依次点亮LED，再按 P1.7-P1.6 -...-P1.0的顺序点亮LED，重复循环。开关断开时，立刻停止点亮指示灯。-keilc+ proteus light parallel port design of experiments requirements: master the 80C51 microcontroller input and output interfaces Society of switch to use the amount of input and output control interface technology and programming methods Experimental subjects: eight light-emitting diodes D1 ~ D8, respectively connected to the MCU P1.0-P1 .7 port on a switch connected to the P3.0 on. Requested output port output " 0" , the light-emitting diode light. Is closed, to embark on the P1.0-P1.1-...- P1.7 in the order light LED, and then P1.7-P1.6-...- P1.0 order light LED Repeat cycle. Switch off when the stop light indicator.

可用由移动通信的好程序，主要做栈队变换，由1343 和cps两种队的变换。-available from the mobile communications program is the main teams do stack transform, and by 1343 cps transform the two teams.

SH7144芯片使用实例 请使用Hew4进行调试-SH7144 chip using examples use the debug Hew4

51开发板源程序,74HC595驱动显示程序.在该模块中，共有4位LED，采用74HC595驱动显示.-51 Development Board source, Bit-driven display program. In this module, A total of four LED, using 74 HC595-driven show.

单片机串口通讯小程序-small microcontroller serial communication procedures

这是arm92440的脉宽调制（pwm） 适合初学者使用-Arm92440 This is the pulse width modulation (pwm) Suitable for beginners to use