一个时时单片机发送数据测试代码

端口控制发光二极管亮灭。 【硬件连接】通过SPCE061A的1位I/O端口（本例中使用IOA15端口），经一限流电阻后接一个发光二极管至地-Port control to eliminate bright light-emitting diodes. [] Through SPCE061A hardware connection of an I/O port (in this example, the use of IOA15 port), with a current limiting resistor followed by a light-emitting diodes to land

基于TI公司的CC1020芯片的无线通讯程序,程序的MCU是TI公司的MSP430系列。-Based on TI

ARM入门初级基础,主要对ARM 学习有个初步了解和认识,即使没接触过单片机的人也可以轻松学习-ARM entry-primary basis, mainly on the ARM to have a preliminary understanding of learning and understanding, even if did not come into contact with SCM can easily learn

atmega32 和RS485的通讯，已经在电路板上测试通过，RS232相对简单一点，RS485需要对控制收发信号处理一下，并且需要RS232转RS485工具来验证收发是否正确-atmega32 and RS485 communication, has been tested in the circuit board, RS232 relatively simple point, RS485 transceiver control signals need to deal with you, and will need RS232 to RS485 transceiver tools to verify the correctness of

LCD C 文件请看看是否合适、请给我加分 第一次上传文件-LCD C requested documents to see if appropriate, please give me extra points first upload documents

使用基本的c语言对led进行颜色、开关等控制，很好用 -use basic language c led right color, switches and other control, with very good

该模拟器是在Keil7.0中使用。 只要把Ex02Dll.dll复制到 X:KeilC51BIN目录下。 打开测试程序，编译运行即可看到如图led.jpg中所显示的效果。-The simulator is used in Keil7.0. As long as Ex02Dll.dll copied to the X : Keil C51 BIN directory. Open test procedure, compile operation can be seen in figure led.jpg reflected by the results.

51单片机串口通讯,介绍在51单片机串口通讯-51 Single-chip serial communications, introduction of the 51 single-chip serial communication

51单片机IIC驱动，包括IIC时序的驱动代码，用C语言编写。-51 Single-chip IIC driver, including the timing IIC driver code, using C language.

crcmodula 进行 校验，在通信无线行业用的比较多-crcmodula to check, in communication with the wireless industry