P T 2 2 5 7 详 细 中 文 资 料

cc2x30_sw_examples: 适用于SmartRF05EB 支持CC2430、CC2530 提供Light_Switch及perTest例程。-cc2x30_sw_examples: apply to SmartRF05EB support for CC2430, CC2530 provide Light_Switch and perTest routine.

基于FREESCALE单片机9S08DZ60的LIN从节点的应用层源代码.LIN是通过UART串口来实现的.开发环境为CODEWARRIOR FOR HC08-Based on Freescale

LED 点阵程序，调试通过，SED2510，-LED dot-matrix program, debug through, SED2510,

avr单片机1wire例子代码-avr SCM 1wire example code

利用8279芯片实现通过2X8键盘输入加数和被加数并计算出结果，同时将加数、被加数和结果都在LED灯上显示出来。-Chip 8279 through the use of 2X8 and keyboard input addend addend and calculated results, at the same time, addend, addend and the results were in the LED lights on the display.

CC2430 基础实验三 按键控制LED闪烁-CC2430 three buttons to control the basis of experimental LED flashes

串口通讯经典使用程序6,以前收集整理的东东,希望对大家有用!-Serial Communication Classic to use the program 6, previously collected Dongdong finishing the hope for all of us!

在keil下 的51 简单的os 51_00_OS-Under 51 in keil simple os 51_00_OS

本程序为数码管显示处理模块 占用I/O RC3,RC4,RC5 使用RAM 节 程序包括: InitSPI 初始化SPI子程序 LEDlight 送七段码显示子程序 入口参数 LED_DATA 出口参数 无-This procedure for the digital display processing module occupied I/O RC3, RC4, RC5 use RAM section include: InitSPI initialize SPI sent to Seven-Segment Subroutine LEDlight code display subroutine parameter exports LED_DATA entrance parameters without

I2C串行总线元器件标准驱动程序的编写，可自己定义串行时钟线和串行数据线所在口-I2C serial bus driver standard components of the preparation, may own definition serial clock line and serial data line I