C8051F系列的TCP/IP源程序C8051F系列的TCP/IP源程序

单片机键盘MakeKey编程-microcontroller programming keyboard MakeKey

采用C51编写的基于C8051F020单片机的电机测速使用程序。-using C51 prepared by the C8051F020 Motor gun procedures.

128×64液晶接口程序，开发出图形，进度条等等许多实用的子程序，方便移植，方便大家！-128 64 LCD interface program to develop graphics, and so on the progress of the many practical subroutine to facilitate transplantation, convenient!

本程序是为51系列单片机开发的16*2型液晶模块驱动程序。该驱动程序包含两个文件，将C文件关联入工程，在调用文件前包含H文件即可。程序提供了简便实用的接口程序，具体使用方法参见文件注释。（本驱动程序在Keil C51开发环境中测试成功，并经过多次实践应用）。-the procedures for the development of single-chip 51 16* 2 LCD driver. This driver contains two files, documents related to C, the call of documents containing H documents. Procedures to provide a simple and practical interface procedures, the use of specific methods, see the Notes document. (Driver in the Keil C51 development environment to test successful, and after several practice application).

单片机设计的遥控电路，遥控码的脉宽数用红外线接收器解码后送单片机读入，发射时由单片机产生40KHZ红外调制信号送红外线发射管发射-Single-chip design of the remote control circuit, remote control code number of the pulse width decoder using infra-red receiver to read single-chip evacuation, launch generated by single-chip modem 40KHZ IR signal sent to the launch tube fired infra-red.

keil C51 Goats事例-examples Goats

NOKIA3310显示屏中文说明，厂家中文的说明。-NOKIA3310 display Chinese that the Chinese manufacturers note.

利用Verilig编写CPLD读写EEPROM（74LC21）程序-Verilig prepared to use CPLD to read and write EEPROM (74LC21) procedures

1总线通信协议应用实例-a bus communication protocol Application

此程序是有关红外的程序 mcu用啊他89c52 采用外部中断0接一体化红外接受头038 （就是影碟机上拆得的） P0 P2接数码管 P0数据 P2位选 能显示遥控器的系统码及其反码 数据及其反码 （共8位） 实际调试成功 工作稳定 测试红外发光二极管的方法 用2v电源 接红外发光二极管 在摄像头下能看到淡紫偏白的光-This procedure is related to the procedure infrared mcu ah him with 89c52 using external interrupt 0 then the integration of infrared to accept the first 038 (that is player on the demolition of a) P0 P2 then P2 digital tube P0 data bit selection can display the remote control system code and its anti-code data and the anti-code (a total of eight) the actual success of the work of debugging and stability testing of the method of infrared light-emitting diodes with 2v power then infrared light-emitting diode in the camera can see under the white light side lilacinus