swarm

matlab,书上例程，仅用作参考，用于数组的重复显示(matlab, books, routines, only as a reference for arrays of repeated)

ROI_of_Simulink 有关Matlab下的simulink的应用，英文版(ROI_of_Simulink)

用MATLAB实现加噪信号的消噪噪,用了三种常用方法。可直接使用。 (Using MATLAB to increase noise and signal noise cancellation noise, with three commonly used methods. Can be used directly.)

高斯光束的傅里叶变换，基于matlab的仿真(Gaussian beam Fourier transform, matlab simulation)

The crf conditions with the airport is a classification model,(The crf conditions with the airport is a classification model)

estymacja w matlabie

说明：  实现图像的正反傅里叶变换，并用fft实现两幅图像的幅相交换(Amplitude and phase s replacement with fft)

非线性方程组求解，里面有很多相关的matlab算法例子。希望对大家有用！(Nonlinear equations, there are many examples of related matlab algorithm. Hope it useful!)

The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):

this is the active noise developed by running an active sysetem