SCPI安柏-AT526仪表测量1-21 数据读取-超时触发

数据采集卡采集拉力值，与预先设定的拉力值进行比较，然后PID运算，控制相应的PWM占空比输出，最终控制电机的速度(The data acquisition card collects the pull value and compares it with the pre-set pull value. Then the PID arithmetic is used to control the output of the corresponding PWM duty cycle, and finally the speed of the motor is controlled.)

BP神经网络研究，用labview实现，简明扼要，非常简单(BP neural network research, realized with labview)

初学者自学labview小程序参考，包括5判断素数、报数问题、自功率谱处理、跑马灯、模拟汽车控制、登陆界面……各种学习小程序(Beginners learning labview applet reference, including five judgments primes, reported few problems, since the power spectrum processing, marquees, simulated vehicle control, landing a variety of learning applet interface ......)

使用 labview 编写的控制界面，控制实验室的光谱仪，测量峰值的光功率(spectrum controller)

通过读取本地CSV文件，筛选里面数据后，传输至指定数据库(By reading the local CSV data, it is transmitted to the database.)

对振动信号采集和分析，包括信号采集，时域分析，品与分析 故障定位(Vibration signal acquisition and analysis)

自己做的PID小程序，里面有一个自己做的温度采样程序(PID do their own small program, which has an own temperature sampling procedures)

LabVIEW 机器人路径规划方面的例子，仔细研究很有用(LabVIEW pathplanning)

测试电源的三相电压，包括幅值、频率、相位等信息。(3 pulse voltage test)

说明：  labview学习资料，花了2W获得的过程学习资料，可以看看很多小例程，值得学习！(LabVIEW learning materials, spent 2W to get the process of learning materials, you can see a lot of small routines, worth learning!)