标定训练原始图片与演示程序

labview网页编程指导资料，建议下载(Labview Web Programming Guidelines, Recommended to Download)

说明：  基于LABVIEW软件采集电压电流信号，运用DAQmx建立任务(Acquisition of voltage and current signals)

基于串口通信的电机控制界面，VI程序 对电机实现参数监控(Based on serial communication motor control interface, VI program to achieve the parameters of the motor monitoring)

说明：  基于myrio的labview编程，包含伺服电机、直流电机驱动、红外对管摄像头等等。(LabVIEW programming based on myrio)

说明：  QPSK BPSK调制解调+USRP,观察（输入、输出、眼图）(modulation and demodulation of QPSK and BPSK+ USRP)

1．采用Labview设计一虚拟函数信号发生器， 通过数据采集卡输出波形信号，调节信号的相关参数，可观察示波器上波形的变化情况。 ⑴ 以NI MyDAQ数据采集卡作为输出接口； ⑵ 数据采集卡输出多种信号，至少完成三种波形：正弦波、三角波、方波(可调占空比)的输出，同时前面板上显示各输出波形； ⑶ 频率、幅值、初相位、直流偏移量和方波的占空比（0～100 ）等参数可以通过前面板控件调节。 ⑷ 前面板可显示输出波形。(1. Labview design using a virtual function signal generator, data acquisition card output waveform signal, adjust the relevant parameters of the signal can be observed on an oscilloscope waveform changes. ⑴ with NI MyDAQ data acquisition card as output interface ⑵ data acquisition card output a variety of signals, to complete at least three waveforms: sine wave output, triangle wave, square wave (adjustable duty cycle), while each of the output waveform is displayed on the front panel ⑶ frequency, amplitude, initial phase, the DC offset and duty cycle square wave (0 to 100 ) and other parameters via the front panel controls to adjust. ⑷ output waveform can be displayed on the front panel.)

labview编写的有漂亮界面的示波器，功能全面(Oscilloscope labview)

使用LabVIEW 如何生成应用程序(exe)和安装程序(installer)在 Windows 平台下使用 LabVIEW 如何生成一个独立可执行程序和安装程序(How to build the application using LabVIEW (exe) and installer (installer) on the Windows platform using LabVIEW how to generate a standalone executable and installer)

采用Labview编写的EMD算法实现过程，没有借助Matlab，完全通过Labiview控件自主完成(EMD algorithm written using Labview implementation process, there is no means of Matlab, entirely independently completed by Labiview controls)

该文件是labview实现例子，写入和读取二进制文件。(This file is an example of LabVIEW implementation, writing and reading binary files.)