DPC

信号的功率谱香农熵和功率谱指数熵 matlab 源程序(Signal power spectrum Shannon entropy and entropy matlab source power spectral index)

自行编写的加入噪声估计的KSVD去噪算法，利用SVD分解进行噪声估计( KSVD denoising algorithm to prepare the addition of noise estimation, the use of SVD decomposition noise estimation )

说明：  出一种新 的SVPWM 算法。采用SPWM 中调制波与载波相比较的规则采样思路，通过在静止坐标系下直接 计算每个参考电压矢量所对应的三相调制波的函数值，进而得到每相电压在一个PWM 周期中的占空比。(A new SVPWM algorithm. SPWM modulation used in the carrier wave, compared with the rules of sampling ideas, through the static coordinate system directly calculated for each reference voltage corresponding to the three-phase vector modulation wave function, which has been in a phase voltage of each PWM cycle accounting air ratio.)

利用Matlab产生各种回声、击掌等特殊效果的音频程序。(Matlab, generate a variety of echo, clap audio programs and other special effects.)

基于负熵最大的独立分量分析算法，可以将独立的混合信号分离(Based on the negative entropy of the largest independent component analysis algorithm can be a separate mixed-signal separation)

说明：  数学建模中的飞行管理问题的matlab程序,分了三个m文件(Mathematical Modeling matlab flight management procedures, were divided into three m file)

自己编程产生一种四进制相位调制信号，为数字调制信号的识别做准备。(programming to produce a quaternary phase modulation signal, the recognition of digital modulation signals in preparation.)

MIMO-OFDM系统的仿真，MIMO-OFDM系统的每个模块都有，都能成功仿真(MIMO-OFDM system simulation, MIMO-OFDM system, each module has, can successfully simulate)

顺便附上几张仿真图 这是状态图 要注意的是：必须把系统状态和kalman滤波器内部预测的状态分开(Incidentally, several simulation map attached to this is the state diagram should be noted that: must be the system state and kalman filter to separate the state of internal forecasts)

说明：  特征提取，人的手的动作等，对这些数据进行捕捉，提取(Feature extraction, human hand movements, etc., these data capture, extraction)