ST4

说明：  计算方法：函数平方逼近多项式的均方误差计算(Calculation method: function square mean square error of approximation calculation of polynomial)

说明：  主要应用于对地震信号，数据的去噪，构造了地震数据然后去噪对比结果，(It is mainly used to denoise seismic signals and data, construct seismic data and then denoise the contrast results.)

本程序是用matlab仿真软件和解析法来计算光子晶体带隙的(this procedure is used Matlab simulation software and analytical method to calculate the photonic bandgap of)

temperature from lm92 to matlab

说明：  输入信号为谐波信号，用brug算法运算线性模型系数。(Input signal for the harmonic signal, using brug coefficient linear model algorithm.)

this code is usefull to calcule the hydraulics properties for a given cross section or batymetric. Also plot the manning properties vs de hydraulic depth

该代码可用于对红外图像的高低温图分别进行一点校正和两点校正(This code can be used for infrared images were a little high and low figure correction and two-point calibration)

WCDMA仿真附完整程序源码，各个功能模块，可运行(WCDMA simulation with complete program source code, the various functional modules can be run)

code of linear programing in matlab

本程序是对V-BLAST系统及其检测算法的仿真，可采用BPSK,QPSK,16QAM,64QAM调制。检测算法为ML，MMSE,ZF,以及采用迫零的连续干扰消除检测算法。(This procedure is the V-BLAST system and its detection algorithm simulation, can be used BPSK, QPSK, 16QAM, 64QAM modulation. Detection algorithm for the ML, MMSE, ZF, and the use of zero-forcing successive interference cancellation detection algorithm.)