PMLSM

说明：  matlab里支持向量机工具箱，好用(matlab in Support Vector Machine Toolbox, easy to use)

simulink搭建的无刷双馈电机控制的矢量控制(Brushless doubly-fed machine control)

常见的潮流程序主要采用直角坐标来进行，本程序采用极坐标对简单输电网系统潮流进行计算(Common trend of the procedure used mainly for rectangular coordinates, polar coordinates, the program uses a simple grid system to calculate the trend)

this is mimo ofdm programm

利用最小二乘法进行拟合多元非线性方程，微分方程组数值解方法，最小均方误差等算法的MSE的计算。( Multivariate least squares fitting method of nonlinear equations, Numerical solution of differential equations method, Minimum mean square error MSE calculation algorithm.)

利用MATLAB进行程序C7_3 QR方法的算法(The use of MATLAB to carry out procedures C7_3 QR algorithm)

说明：  精通MATLAB优化计算算法，非线性最小二乘问题。共3个程序。(Proficient in MATLAB optimization calculation algorithm, nonlinear least squares problems. A total of three procedures.)

编写M文件，创建如下图形窗口，分别绘制如下图所示的曲线。 （1）曲线y=sin(t)sin(9t)，要求采用红色，点线。横坐标取值范围[0~ ]，标注x轴、y轴并加标题。 （2）一组余弦曲线，其振幅分别为0.4，0.6和0.8。横坐标取值范围[0~2 ]。添加图例与标题。进入图形编辑状态，调整图例的位置。 （3）分别绘制peaks函数的曲面图和网格线图。对曲面图做平滑处理，并添加标题与colorbar。 (Write M file, create the following graphics window, curves were plotted as shown below. (A) the curve y = sin (t) sin (9t), require the use of a red dotted line. The abscissa in the range [0 ~  ], labeled x-axis, y-axis and a title. (2) a set of a cosine curve, and the amplitude was 0.4, 0.6, 0.8. Abscissa value range [0 ~ 2  ]. Add a legend and title. Into the graphical editing mode, adjust the position of the legend. (3) were drawn surface chart peaks function and grid line graph. Surface charts do for smoothing and add titles and colorbar.)

内模控制实现程序 基于MATLAB2010a环境下实现(Implement procedures based on internal model control environment to achieve MATLAB2010a)

附件中的pdf文件是韩国作者08年在Automatica上发表的文章。本代码给出了文章中定理1的线性矩阵不等式的求解程序，通过给定不同的a来求解最大的b,进而得到界定时滞系统的最小的椭圆。(Attached pdf file of 2008 in South Korea articles published in Automatica. This code is given in Theorem 1 article LMI solver through a given different to solve the biggest b, then get the minimum of delay systems defined ellipse.)