登录
首页 » matlab » 2ASK

2ASK

于 2017-12-28 发布 文件大小:1KB
0 225
下载积分: 1 下载次数: 4

代码说明:

  二进制振幅键控基于MATLAB的调制解调代码(Modulation and demodulation code based on MATLAB based on binary amplitude keying)

文件列表:

2ASK.txt, 2330 , 2017-12-28

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • qgriddata
    These files are for cfd
    2010-12-09 15:57:11下载
    积分:1
  • newton
    Cauchy s Method for Multiple Variable Functions
    2010-12-22 12:54:44下载
    积分:1
  • Ali
    ALAMOUTI performs Monte-Carlo simulation and estimates Bit Error Rate (BER) of Alamouti Scheme [1] over Rayleigh channel
    2015-04-04 10:04:23下载
    积分:1
  • MATLAB
    張智星的MATLAB介紹,主要是學習MATLAB的應用,如何操作和模擬。(Zhang Zhi-sing introduction of MATLAB, mainly studying the application of MATLAB, how to operate and simulation.)
    2009-03-17 15:18:24下载
    积分:1
  • Parallel_Optimization
    Speeding Up Optimization Problems with Parallel Computing - Webinar - 10 August 2010
    2012-08-01 01:45:54下载
    积分:1
  • EdgeDetection
    MATLAB里的simulink的dspbuilder设计的图像边缘检测,可直接运行,并可通过matlab转化到quartus中并下载到FPGA运行(Edge Detection of MATLAB simulink where dspbuilder design can be directly run, and transformed by matlab to quartus and downloaded to the FPGA run)
    2015-04-16 22:47:42下载
    积分:1
  • VoiceBox_Matlab
    Voicebox Matlab m files
    2013-10-20 01:49:58下载
    积分:1
  • ICEE-574
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:54:09下载
    积分:1
  • Lab1
    Small code for testing p, pi and pid controllers at matlab.
    2011-09-14 11:44:23下载
    积分:1
  • DSP_FFT
    产生两不迥频率的信号,并对两信号作复数FFT变换,找出频率为50Hz的信号对其进行能量计算(Two distant signal is not generated frequency, and two signals for complex FFT transform to identify the frequency of 50Hz signal to calculate its energy)
    2013-12-01 10:35:35下载
    积分:1
  • 696516资源总数
  • 106914会员总数
  • 0今日下载