Arduino485cs1180

一篇关于细纱机控制设计的论文，通过单片机对细纱机控制。(Control design on a paper frame by frame control micro.)

PLC程序 施耐德PLC 通过CANOPEN控制3台伺服器(PLC Schneider PLC program control by CANOPEN 3 servers)

The Laplace transform is an integral transform perhaps second only to the Fourier transform in its utility in solving physical problems. The Laplace transform is particularly useful in solving linear ordinary differential equations such as those arising in the analysis of electronic circuits.

FPGA控制AD7321的模块，是本人亲自试验过的。有Verilog源码，和简单文档(Fpga control module of ad 7321, is I personally tested. Verilog source code, and simple documentation)

基于TI公司的msp430g2553单片机的lcd显示程序，好用(Based on TI company s msp430g2553 MCU LCD display program, absolutely easy to use)

说明：  提取nastran生成的刚度和质量矩阵，希望有用(The stiffness and mass matrices generated by NASTRAN are extracte)

RS485主机从机通信，程序分模块变成，注释详细(RS485 master slave communication, procedures, sub-modules into a, more notes)

对意法半导体最常用的32位单片机位带操作的理解(STMicroelectronics appreciated that the most commonly used 32-bit microcontroller operation)

说明：  AD5933模块负阻抗测试程序，C语言Keil编译(AD5933 Impedance Test Program)

接收SI4463数据 并上传到电脑。同时发送一个确认代码给分机。(Receive SI4463 data and upload it to the computer.At the same time, send a confirmation code to the extension.)