8b10b Verilog

Cooperative MIMO matlba source code

DXF轨迹图转G代码，有 直线，圆，圆弧，样条曲线，优化多段线，多段线。与下位机串口通讯！无法编译，是因为要先注册mscomm控件(DXF trajectories turn the G-code, line, circle, arc, spline curves to optimize the polyline, polyline. With lower serial communications! Not compile because the first registered mscomm controls)

在OPNET上搭建场景，仿真接入算法，使用的是S-ALOHA接入算法，以仿真吞吐量、时延等性能(Build a scene on OPNET, simulation access algorithm, using the S-ALOHA access algorithm to simulate the throughput, latency and other performance)

该工程实现对单载波系统QPSK的频偏估计算法。调相信号在接收机相干解调时需要同频同相的参考载波，而发射机和接收机之间往往存在频率偏差，为了消除这种误差，必须在软件层面实现。使用了QPSK四相调制的信号特点进行载波频偏估计，经验证，效果较好。(This project implements frequency offset estimation algorithm for single carrier system QPSK. The phase modulation signal needs the same frequency reference carrier in the coherent demodulation of the receiver, and the frequency deviation often exists between the transmitter and the receiver. In order to eliminate this error, it must be implemented on the software level. The carrier frequency offset estimation is carried out by using the signal characteristics of QPSK four phase modulation.)

说明：  TI RTOS 教材，难得好资料，基于TI RTOS软件开发人员的必备参考(TI RTOS handbook, show how to use TI RTOS)

OFDM系统的自适应功率和比特分配算法，实现系统资源的自适应分配（4)－－原创(adaptive allocation for OFDM system)

最简单的串口收发程序，全部用VC++实现，对初学VC串口通信的朋友有很大帮助，提供全部源代码，提供串口类的.CPP和.H文件。(The simplest procedure serial transceivers, all with VC++ implementation of serial communication beginner VC friend of great help, providing all the source code, to provide serial port class. CPP and. H files.)

线性调频信号和相位编码信号（七位巴克码）及他们的混合调制信号在matlab中的实现(The realization of the chirp signal and the phase-encoded signal (seven Barker code) and their hybrid modulation signal in matlab)

本程序是对V-BLAST系统及其检测算法的仿真，可采用BPSK,QPSK,16QAM,64QAM调制。检测算法为ML，MMSE,ZF,以及采用迫零的连续干扰消除检测算法。(This procedure is a V-BLAST system and its detection algorithm of the simulation, using BPSK, QPSK, 16QAM, 64QAM modulation. Detection algorithm for the ML, MMSE, ZF, and the introduction of zero-forcing successive interference cancellation detection algorithm.)

实现基于STBC的MIMO_OFDM通信系统在不同信噪比情况下接收端的误比特率的仿真。发射端包括基于基带调制、空时编码、导频插入、IFFT、串并合并以及添加循环前缀；接收端包括去除循环前缀、取出导频估计信道、FFT运算以及并串合并，空时解码等。仿真中采用QPSK、空时编码采用4*3的复正交空时编码矩阵。OFDM子载波数为100，每个子载波传输66个符号，每个符号2比特。IFFT长度为512个符号。发射天线为3个接收天线为2个。(The BER simulation of MIMO_OFDM communication system based on STBC under different SNR is realized. The transmitter includes baseband modulation, space-time coding, pilot insertion, IFFT, serial-parallel combination and adding cyclic prefix; the receiver includes removing cyclic prefix, extracting pilot estimation channel, FFT operation, parallel-serial combination, space-time decoding, etc. The complex orthogonal space-time coding matrix is used in QPSK and space time coding in 4*3. The number of OFDM subcarriers is 100, and each subcarrier transfers 66 symbols with 2 bits per symbol. IFFT is 512 symbols in length. The transmitting antenna is 3 receiving antennas, 2.)