AD5422

单片机AD功能实例，使用1602显示电压(SCM AD function example, the use of 1602 shows the voltage)

BOOT引导IAP应用演示程序-目标MCU:MEGA8 晶振:外部(EXT) 8MHZ (BOOT boot IAP application demo program- Target MCU: MEGA8 Crystal: External (EXT) 8MHZ)

说明：  答题器源码，用51单片机控制的。具体内容自己下载看吧(Answer source browser, with 51 single-chip control. Download and see the specific content of their own)

AT89C51SND1C方案mp3资料包括源程序与原理图(AT89C51SND1C program information, including source code and mp3 schematic)

51单片机入门学习资料，适合初学者下载。(Getting Started 51 MCU learning materials, suitable for beginners to download.)

网络控制单片机proteus仿真 利用网络控制单片机的LED、LCD，我只是整理了一下，方便大家学习，版权归原作者，网页也麻烦站长做好了，有一个上位机，点击自动运行一段程序和打开www.mcufz.com/tcp.htm，之后会自动关闭，有的杀毒软件会报是病毒，放心使用。 开始要安装一个WinPcap软件，不安装它不能仿真，然后运行仿真文件，过一会可以看到LCD显示出了IP地址50。1。1。1 (Proteus simulation network control the use of single-chip microcontroller network control LED, LCD, I am just finishing a bit, to facilitate learning, belongs to original author, the website also do a good job of head trouble, there is a host computer, click Automatic operation for some procedures and open www.mcufz.com/tcp.htm, will automatically shut down after some anti-virus software will be reported to viruses, ease of use. WinPcap started to install a software, do not install it can not simulation, and then run the simulation documents LCD moment we can see the IP addresses shows that 50. 1. 1.1)

TIF2801的modbus协议程序，带仿真函数(Modbus for TIF2801)

nRF905接收程序,可与k60连接进行无线通信(RF905 receiving program can communicate wirelessly connect with k60)

基于51单片机的信号发生器 四种波形显示 有级调频(Based on 51 single-chip signal generator)

This is AS1130 Datasheet