ABAQUS与Python

umat基础知识教学，适合刚接触UMAT的新手做参考(UMAT basic knowledge teaching, suitable for beginners)

基于回归分析的负荷预测，包括了最小二乘回归和偏最小二乘回归(Load forecasting based on regression analysis)

说明：  这个是信号与处理专业的大作业，主要研究两个方面的问题：低通滤波器的阶跃响应特性分析和连续线性系统的求解。通过这次课程设计，将会研究Matlab的一些基本的数值计算应用方法，对计算结果进行形象化地展示，有利于加深对本课程内容的理解。(This is a major task of signal and processing specialty. It mainly studies two aspects: step response characteristic analysis of low-pass filter and solution of continuous linear system. Through this course design, we will study some basic numerical calculation application methods of MATLAB, and visualize the calculation results, which is conducive to deepening the understanding of the course content.)

说明：  对于非线性模型的跟踪预估问题，摒弃额对非线性函数进行线性化的做法，采用无迹变换处理均值和方差的非线性传递问题。(For the tracking and prediction problem of the nonlinear model, the linearization of the non-linear function is abandoned, and the traceless transformation is used to deal with the non-linear transfer of mean and variance.)

常规波束形成与最小方差无畸变算法性能对比（CBF、MVDR）(Performance comparison between conventional beamforming and minimum variance distortionless algorithm CBF MVDR)

说明：  matlab画三维凸包，根据一些离散点，效果非常好(Matlab draws three-dimensional convex hull, according to some discrete points, the effect is very good.)

说明：  三个ANSYS瞬态分析的命令流：冲击载荷作用悬臂梁的阻尼振动分析；破碎锤的瞬态动力学分析；滑动摩擦接触分析(Three command streams of ANSYS transient analysis: damped vibration analysis of cantilever beam under impact load; transient dynamic analysis of crushing hammer; sliding friction contact analysis)

统一潮流控制UPFC仿真模型，230kV(Unified power flow control UPFC simulation model, 230kV)

说明：  voce非线性各向同性强化弹塑性本构子程序（ansys格式）(voce-Nonlinear-Isotropic Hardening usermat)

光伏仿真模型和boost-buck模型，适合做微网或者交直流微网的学者研究(Photovoltaic simulation models and boost-buck models are suitable for microgrid or AC-DC microgrid researchers.)