Beggs-Brill

蒸发冷凝的udf，，包括传热传质，对应于水(Evaporative condensation of UDF, including heat and mass transfer, corresponds to water)

一个变电站系统的运行模拟程序，基于vc。(A substation operation of the system simulation program , based on the vc)

水库调度 单库POA，以乌江梯级水库群中单库东风为例(The reservoir scheduling single library POA)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

电力系统稳态分析-课程作业-用牛顿拉夫逊法求解潮流-C++下编译通过，注释清晰，思路清楚，值得参考。(Steady power system analysis- coursework- Newton Raphson method to solve the current-C++ compiler, comments clear, clear thinking, good reference.)

《电力系统稳态分析》第三版，中国电力出版社，书上P95页，例3-4。经过计算机C语言编程，运用牛顿拉夫逊法，把简单的电力系统潮流进行计算。(load calculation)

说明：  美国ATMP公司,X光谱分析仪硬件数据采集精简版部分MFC包装程序，本程序采用VS2008编译通过。 (U.S. ATMP company, X spectrometer data acquisition hardware part of MFC wrapper Starter Edition, the program uses VS2008 compile.)

本程序为基于多回路理论的单相异步电机故障诊断程序，具有良好的效果(This program is based on multi-loop theory for single phase induction motor fault diagnosis procedures, with good results)

最小平方反褶积的相关程序，可用于相关地震资料的处理和分析(Least squares deconvolution procedures, can be used for correlation of seismic data processing and analysis)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)