SEG2SGEY

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

第一类高阻抗含气砂岩AVO正演（自激自收）(The first class of high-impedance gas sands AVO forward)

该程序计算翅片式冷凝器选型软件，制冷剂为R22,根据冷媒侧进出口参数求换热面积。比较实用的(The program calculates fin type condenser selection software, refrigerant R22, according to refrigerant side inlet and outlet parameters for heat exchange area. More practical)

采用MD5加密的采制化三级编码管理系统，对燃煤电厂入厂煤采制化进行管理。(Use md5 encryption for heat-engine English level 3 coding management system)

大型风电场接入电网的稳定性问题研究,希望对大家有点启发( the problems of Large wind farms connected to the grid stability)

ASN.1 编码规则：分组编码规则,各种数据类型的ASN.1的编码方式,非常有用,值得一看(ITU-T Recommendation X.690 (2002) | ISO/IEC 8825-1:2002, Information technology –ASN.1 encoding rules:Specification of Packed Encoding Rules (PER))

计算离散信号的振幅谱和相位谱 1. 编写计算DFT的程序。 2. 编写计算振幅谱和相位谱的程序。 (DSP)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

本程序为基于多回路理论的单相异步电机故障诊断程序，具有良好的效果(This program is based on multi-loop theory for single phase induction motor fault diagnosis procedures, with good results)

用于计算石油工业中油管内的循环压耗，可以解决石油工业中的有关管路压耗计算的问题。(failed to translate)