工程1

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

运用加权最小二乘法进行电力系统状态估计 具有较好的收敛性 但适合于较小的系统(Using weighted least squares state estimation of power system has a good convergence, but for smaller systems)

说明：  IEEE5节点经典算例程序，非常完整的潮流计算程序，对电力系统自动化专业的学生非常有用 (IEEE5classic example node procedure is a complete flow calculation procedure of the power system is very useful for students Automation)

atp是电力系统暂态仿真软件，在atp仿真软件上建立了IEEE三机九节点的仿真模型，并得到了潮流及稳定的仿真结果(atp is the power system transient simulation software, simulation software in the atp built on the IEEE three-machine nine nodes in the simulation model, and has been the trend and stability of simulation results)

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

计算离散信号的振幅谱和相位谱 1. 编写计算DFT的程序。 2. 编写计算振幅谱和相位谱的程序。 (DSP)

水库调度 单库POA，以乌江梯级水库群中单库东风为例(The reservoir scheduling single library POA)

这个程序主要用于计算电力系统的潮流，进而了解电力系统的运行状态。(This procedure used to calculate the power flow, and then understand the power system operating state.)

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)

说明：  美国ATMP公司,X光谱分析仪硬件数据采集精简版部分MFC包装程序，本程序采用VS2008编译通过。 (U.S. ATMP company, X spectrometer data acquisition hardware part of MFC wrapper Starter Edition, the program uses VS2008 compile.)