Least-square-deconvolution

IEC101-104 电力规约通讯实现及测试软件，VC2003下编译运行通过。支持串口以太网(IEC101-104 power protocol communication and testing software, VC2003 compiler run through. Support serial port Ethernet)

用于计算石油工业中油管内的循环压耗，可以解决石油工业中的有关管路压耗计算的问题。(failed to translate)

频率波数域波动方程正演（单点模拟也可随意给）(Frequency-wavenumber domain wave equation forward (single-point analog also be free to give))

8MPa 下 CO2/H2O质量比96 /4 的物性参数 适用于东芝超临界二氧化碳循环工质(8MPa under the CO2/H2O mass ratio of 96 /4 of the physical parameters for Toshiba supercritical carbon dioxide circulating fluid)

说明：  美国ATMP公司,X光谱分析仪硬件数据采集精简版部分MFC包装程序，本程序采用VS2008编译通过。 (U.S. ATMP company, X spectrometer data acquisition hardware part of MFC wrapper Starter Edition, the program uses VS2008 compile.)

电力系统稳态分析-课程作业-用牛顿拉夫逊法求解潮流-C++下编译通过，注释清晰，思路清楚，值得参考。(Steady power system analysis- coursework- Newton Raphson method to solve the current-C++ compiler, comments clear, clear thinking, good reference.)

蒸发冷凝的udf，，包括传热传质，对应于水(Evaporative condensation of UDF, including heat and mass transfer, corresponds to water)

求取两个信号的到褶积，通常在用地震方法找油气中用雷克子波和反射系数求取褶积，本程序只是搭建了一个大致的框架，如果需要的到结果，还需要自行设置信号和一些参数。(Strike to the convolution of two signals, typically using seismic methods used to find oil and gas Ricker strike wave and reflection coefficient convolution, this procedure is to build a general framework, if the desired results, you need to set your own signal and some parameters)

锅炉热平衡计算是指输入锅炉机组的热量和锅炉机组输出热量之间的平衡(Boiler heat balance calculation refers to the input heat boiler unit and boiler unit balance between the heat output)

计算离散信号的振幅谱和相位谱 1. 编写计算DFT的程序。 2. 编写计算振幅谱和相位谱的程序。 (DSP)