qiutiu_V7.3

数据检测,运用于多径传输的数据检测的matlab源代码(data_test，applying to multiply-transfrom)

如何生成可独立运行的Matlab程序.介绍了Matlab C数学库、Matlab C++数学库、Matcom、Matlab COM Builder、Matlab Engine及编译Matlab独立可执行程序等Matlab混合程序设计的内容。 (How to build can be run independently of Matlab programs)

Matlab的Gabor滤波器代码，使用方法: I = imread( 图像文件名 ) [G,gabout] = gaborfilter1(I,2,4,16,pi/3) figure,imshow(uint8(gabout)) (Gabor filter Matlab code, use the method: I = imread ( image filename ) [G, gabout] = gaborfilter1 (I, 2,4,16, pi/3) figure, imshow (uint8 (gabout) ) )

说明：  simulink，APF，Ip—Iq的检测方法，直流电压控制，滞环控制(simulink active power filter,ip/iq detection method,C voltage control, Hysteresis control)

信号通过信道外编码、信道内编码、交织、去交织、信道内解码、信道外解码的过程，在高斯噪声和突发干扰的影响下通过matlab仿真完成信道在不同干扰下的误码率曲线，分析各编码对误码率的影响。 (The signal through the outer channel coding, in-channel coding, interleaving, de-interlacing, in-channel decoding, channel decoding outside the process, Gaussian noise and burst under the influence of interference by the completion of matlab simulation in different interference channel bit error rate curve of , analysis of the coding of the bit error rate.)

fluid mechanics article

PPT of Pattern Classification Chapter 1

Get Homograpy Between Two Image. Run in matlab development enviroment.

加入重复控制，用谱方法计算流体力学一些流动现象的整体稳定性,部分实现了追踪测速迭代松弛算法。( Join repetitive control, Spectral methods of computational fluid dynamics flow of some of the overall stability of the phenomenon, Partially achieved tracking speed iterative relaxation algorithm.)

说明：  本资源为双馈风机DFIG的建模，其中包括定子直接从电网以恒定的振幅和频率提供三相电压。转子还由三相电压供电，这些三相电压在稳定状态下具有不同的幅度和频率，以便达到电机的不同运行条件（速度，转矩等）。本资源在intin.m文件中给了具体的参数，可以模拟出具体的仿真结果，使用者也可以自己改变参数来模拟仿真自己的结果。(This resource is for modeling DFIG of doubly fed wind turbine, which includes the stator providing three-phase voltage directly from the grid at constant amplitude and frequency. The rotor is also powered by three-phase voltages, which have different amplitudes and frequencies in steady state to achieve different operating conditions (speed, torque, etc.) of the motor. This resource provides specific parameters in the InTin. M file, which can simulate the specific simulation results. Users can also change the parameters to simulate their own results.)