MIMO_OFDM

this code is for EMD decomposition

电动机的矢量仿真模型。这是基于矢量控制的simulink仿真模型。(Motor vector simulation model. This is based on vector control simulink simulation model.)

卡尔曼滤波仿真，对于初学卡尔曼滤波器的人有很大的帮助(Kalman filter simulation Kalman filter for the beginner who has a lot of help)

基8-DFT计算，每8点为一蝶形运算单元，4096点计算效率较基2-DFT提高50 (Yl 8-DFT calculation, every 8 points for a butterfly operation unit, the 4096-point computation efficiency than the base 2-DFT increased by 50 )

基于压缩感知(应用匹配追踪算法)处理二维信号(MP2D compressed sensing using mp)

本人对经典Maxflow算法的修改，实现的是C++和Matlab混合编程。cpp源码可以在matlab下编译，该实现方式比纯matlab实现效率高出好多。(I classic Maxflow algorithm changes, realize that the C++ And Matlab programming mixed. cpp source code can be compiled under matlab, the matlab realize than pure efficiency than many realize.)

说明：  基于负熵的ICA算法，独立成分分析；负熵；盲信号分离；固定点(Negative entropy based ICA algorithm, independent component analysis negative entropy blind signal separation fixed point)

用Matlab作图时，特别是所作的图是要用于科研论文投稿时，对图的大小有一定要求。但用缺省设置作图时，图的大小不能控制，而且常常有大块的空白。本程序可控制图的大小和位置，并能自动去掉空白。(Using Matlab mapping, especially of the map is to be used for scientific research papers submission, the size of the map has a certain requirement. However, when using default settings mapping, map the size of control, often have large gaps. This procedure can control the map size and position, and can automatically remove blank.)

利用GPSR-BB算法重构二维图像，简单易懂。(GPSR-BB algorithm using two-dimensional image reconstruction, easy to understand.)

Matlab2微分方程的数值解法,介绍解非线性微分方程的算法及如何用Matlab实现。(Matlab2 Numerical Solution of Differential Equations, Introduction Algorithm Solution of Nonlinear Differential Equations and realize how to use Matlab.)